Temperature Distribution Analysis
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC018] Thermal Analysis of a Motor
In this example, how to evaluate a motor's temperature distribution by creating a thermal analysis model that can investigate the loss analysis and temperature distribution in ord…
-
[JAC228] Induction Motor Thermal Analysis
In this example, evaluating induction motor temperature distribution.
-
[JAC233] Induction Heating Coil Optimization
In this example, an example of using an optimization function to design a coil to use for induction hardening a gear is presented.
-
[JAC198] Bus Bar Thermal Stress Analysis
Here, temperature distributions for bus bars are obtained when the power supply frequency is changed.
-
[JAC044] Resistance Heating Analysis of a Steel Sheet
This Application Note presents how to obtain the calculate current density distribution, Joule loss distribution and temperature distribution of steel sheet.
-
[JAC206] Temperature Analysis of an Oil-Immersed Transformer Using a Coupled Magnetic Field and Thermal Fluid Analysis
This document introduces, examples and steps will be shown to obtain heat distribution in a magnetic field analysis for a forced circulation type oil-immersed transformer, map the…
-
[JAC208] High Frequency Induction Hardening Analysis Accounting for Deformation (Abaqus Link)
This document introduces evaluates how heating ranges change depending on the deformation amount at high temperatures and deformation during heating, with heat generation analysis…
-
[JAC249] Dielectric Heating Analysis of a High-Frequency Preheater with Parallel Plate Electrodes
In this example, a use case evaluating the influence on the temperature distribution of materials (tablets) with and without auxiliary electrodes is presented.
-
[JAC250] Dielectric Heating Analysis of a High-Frequency Preheater with Roller Electrodes
In this example, a use case is presented where the influence of the pitch of roller electrodes on the temperature distribution of a material (tablets) is evaluated.
-
[JAC218] High-Frequency Induction Hardening Analysis Accounting for Deformation
In this example, using the JMAG magnetic field - thermal stress coupled analysis function, analysis is performed evaluating gear deformation from induction heat hardening.
-
[JAC220] Analysis of the High-Frequency Induction Hardening and Cooling of a Gear
In this example, deals with induction heating and cooling analysis. An example is presented where the cooling rate for a gear differs depending on the cooling conditions.
-
[JAC186] Gear Induction Hardening Analysis Using Two Frequencies
In this material, the validity of coil geometry used for quenching is evaluated by heating the gear top and bottom at high and low frequencies, respectively, to confirm uniform te…
-
[JAC279] Thermal Analysis Accounting for Cooling of the IPM Motor
In this example, thermal equivalent circuit is used to run thermal analysis of a 3-phase IPM motor that accounts for cooling, and check the temperature change in the coil.
-
[JAC123] Thermal Analysis of a Choke Coil
This Application Note shows the use of a thermal analysis to obtain the temperature distribution using the iron losses and copper losses in the choke coil as the heat source.
-
[JAC127] Resistance Heating Analysis of Steel
This Application Note presents how to obtain the temperature distribution, temperature variations, and heat flux distribution in a body heated by ohmic heating.
-
[JAC130] Thermal Conductivity Analysis of Basic Geometry
In this Application Note, the analysis accuracy is investigated by comparing the temperatures obtained through analysis in each part with theoretical values.
