FQ
Time Harmonic Magnetic (2D/3D)
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC203] No-Load Test Analysis of Power Transformer
This example focuses on modeling in the analysis of no-load tests in JMAG and obtains the magnetic flux line, current, excitation conductance, and excitation susceptance that can …
-
[JAC227] Circuit Control Simulation for Three-Phase Induction Motor
In this example, we conduct a circuit simulation to control current and speed by incorporating the JMAG-RT model of an induction motor into the control/circuit simulator.
-
[JAC280] Topology Optimization of Induction Heating Coil
In this example, magnetic field and thermal coupled analysis is run, and using topology optimization, searches are performed for a heating coil that maximizes the power factor and…
-
[JAC190] Arrangement Optimization of Wireless Power Transfer System
This document introduces the procedure in obtaining the optimum solution for geometries of transmission coils (angle that defines position) for simple magnetic resonance wireless …
-
[JAC278] Creating Six-Phase Induction Motor Efficiency Maps
In this example, a six-phase induction motor efficiency map is created in the concept design stage, and each operating point slip and iron loss are evaluated.
-
[JAC224] Wireless Power Transfer Device Stray Loss Analysis
In this example, an example is presented investigating by using electromagnetic field analysis whether stray loss can be suppressed using an aluminum shield.
-
[JAC233] Induction Heating Coil Optimization
In this example, an example of using an optimization function to design a coil to use for induction hardening a gear is presented.
-
[JAC217] Creating Efficiency Maps for 3-Phase Induction Motors
In this example, the use of JMAG-RT Viewer to create efficiency maps for three-phase induction motors when drive temperatures change.
-
[JAC113] Power Transmission Analysis of a Wireless Power Transfer System with Opposing Cores
This Application Note presents how to obtain the power transmission efficiency when the feeder wire’s position is moved in both the horizontal and vertical directions from a refer…
-
[JAC032] Analysis of a Transformer
In this example, the use of a magnetic field analysis to evaluate changes in the secondary voltage caused by load variations in a low frequency transformer.
-
[JAC254] Vibration Analysis of a Large Oil-Filled Transformer
In this example, evaluating vibration caused by electromagnetic excitation in a large transformer. Since large transformers are oil-cooled, in this example the oil, which is the f…
-
[JAC208] High Frequency Induction Hardening Analysis Accounting for Deformation (Abaqus Link)
This document introduces evaluates how heating ranges change depending on the deformation amount at high temperatures and deformation during heating, with heat generation analysis…
-
[JAC218] High-Frequency Induction Hardening Analysis Accounting for Deformation
In this example, using the JMAG magnetic field - thermal stress coupled analysis function, analysis is performed evaluating gear deformation from induction heat hardening.
-
[JAC220] Analysis of the High-Frequency Induction Hardening and Cooling of a Gear
In this example, deals with induction heating and cooling analysis. An example is presented where the cooling rate for a gear differs depending on the cooling conditions.
-
[JAC221] Confirmation of the Influence from the Reduction of High-Frequency Resistance of a Magnetically Plated Wire Choke Coil
In this example, high frequency resistance values are obtained from choke coil copper loss analysis results using JMAG’s layer coating mesh function, and the effectiveness of redu…
-
[JAC202] Core Stray Loss Analysis of Power Transformer
This document introduces runs analysis by modeling the short-circuit test that is conducted when evaluating stray loss and obtains stray loss distribution in the core close to the…
