To our valued customer,

Webinar with subtitles in multilingual:
“Brush up on Motor Design!” Vol.16 has been released!

“Brush up on Motor Design!” by Prof. Miller, an authority on motor design is available on our website.
From beginners in motor design to experts in design and analysis, this content can be of reference to everyone.

The following webinars have been published this month.
You can view it not only in English but also in many languages!

[Vol.016] IPM Interior Permanent-Magnet Motor (Part 2 : Open-Circuit Calculation)

In this 16th seminar, we will be covering discussion regarding IPM motor open-circuit calculations.
We take for consideration an open-circuit where the rotor is inserted into the stator, and where no current is flowing in the stator coils. The ideal magnetic flux density distribution in the air-gap is calculated approximately with the magnetic equivalent circuit method, and FEA is used to check the harmonic component that occurs as a result of the stator slots, etc.
Through the changes of the operating point of the magnet on its demagnetization curve, I then explain the effect of the leakage flux that occurs due to the air-gap and the bridges.

You can also make inquiries to Prof. Miller if you have any questions. There is a comment form at the bottom of each seminar page.
If you have any comment, please!!

On-demand Webinar

In addition, we have published columns on various themes.
We recommend first taking a look at Column: “An engineer’s diary”.

Read the column

JMAG & PSIM Users Conference 2021

This is to announce that the European JMAG distributor POWERSYS will be holding the JMAG&PSIM Users Conference 2021.
This conference will center around case studies using JMAG and PSIM, and will be held online from September 27th to October 1st, 2021.

Experts and developers in the field of electricity and power electronics will be in assembly at the conference, with those from countries outside of Europe also more than welcome to take part.
We look forward to your participation.

Please see the following page for the details.

For more Information