Design Exploration / Optimization

Sort condition
Newest first
Oldest first
Large number of views
  1. [JFT065] Obtaining Part Face Area and How to Set Conditions

    This document explains how to set current values for a coil area.

  2. [JFT124] Searching for the Parameter Range Reducing Geometry Collapse During Optimization Calculations

    This document describes the method for using the functions useful in searching parameter ranges that reduce geometry collapse during optimization calculations.

  3. [JFT070] Creating PM Motor Efficiency Maps Using JMAG-Designer (Accuracy Priority Mode)

    This document describes how to create efficiency map studies (accuracy priority mode) using a JMAG-Designer efficiency map study (speed priority mode).

  4. [JFT152] Output of Response Values Using Surrogate Models

    In this document, a macro is provided for quickly evaluating the results obtained by design parameter combinations using surrogate models. This document, as a workflow for paramet…

  5. [JFT146] Optimization Calculation Using Surrogate Models

    This document describes as the workflow for optimization calculations using surrogate models creating training data, creating the sample case, and using a surrogate model in runni…

  6. [JFT097] Optimization Execution Using Material Characteristics as Design Variables

    In this document, how to perform optimization with material characteristics used as design variables is presented.

  7. [JAC233] Induction Heating Coil Optimization

    In this example, an example of using an optimization function to design a coil to use for induction hardening a gear is presented.

  8. IMS Co., Ltd.

    Since its founding, IMS Co., Ltd. has continued to support advanced technology development of magnetic application products.

  9. [JFT135] Distributed Execution of Topology Optimization Calculation Using SSH

    This document describes how to perform topology optimization calculations with the on/off method on a Linux remote machine via SSH.

  10. [JFT122] Executing Optimization Calculations Using Reduced Order Models

    This document describes the method for executing simple analysis and optimization using a reduced order model.

  11. [JFT131] Evaluating Degrees of Similarity for Geometry Using NGnet Weight

    This document describes a method where after executing topology optimization using NGnet, degrees of similarity for geometry from NGnet weight are evaluated.

  12. [JFT125] Inheriting Operating Points Between Modes in Efficiency Map Studies

    This document describes the method for using operating point information obtained with speed priority mode in accuracy priority mode.

  13. [JFT136] Sending SSH Settings to Remote Machines

    This document describes the method for sending SSH settings configured on local machines to remote machines for executing other case calculations.

  14. [L-OP-25] Utilizing JMAG in Cloud Services

    More cloud services for CAE continue to be offered. This allows sufficient computational resources to be used when needed to perform analysis work.

  15. [W-OP-96] Necessity of GA for Multi-Objective Optimization of Drive Motor

    In this paper, the multi-objective optimization calculation has 12 design variables (8 geometric variables, 4 circuit variables) with 6 objective functions (maximize torque, minim…

  16. [L-OP-34] Using MATLAB’s Optimization Engine in JMAG

    MATLAB is widely used in the engineering field, and the MATLAB Global Optimization Toolbox is often used for optimization calculations also.

Search Filter

  • All Categories

Remember me
Sign In
Create an account (Free) About authentication ID for JMAG website