Page: 16/21

5-minutes Motor Design

Return to the first
  1. Confirm requirements
  2. Select template
  3. Import template
  4. Sizing
  5. Set design variables
  6. Set winding
  7. Change dimensions
  8. Change materials
  9. Set drive conditions
  10. Evaluate characteristics of the initial proposal
  11. Customize evaluation result graph
  12. Confirm torque and power of initial proposal
  13. Confirm inductance
  14. Run parametric analysis of current phase
  15. Compare results
  16. Run parametric analysis of gap length
  17. Compare results
  18. Select improvement plan
  19. Adjust drive conditions and evaluate
  20. Displaying the Results
  21. Enclosure
<< Prev Next >>
Use parametric analysis to confirm changes in characteristics when air gap is changed. Click on the value in gap length at the bottom table and set 1 for the number of divisions between 0.5 mm and 1.5 mm.
Clear the check boxes for 45 deg and 55 deg in the table above to compare current phase with 65 deg.