Page: 18/21

5-minutes Motor Design

Return to the first
  1. Confirm requirements
  2. Select template
  3. Import template
  4. Sizing
  5. Set design variables
  6. Set winding
  7. Change dimensions
  8. Change materials
  9. Set drive conditions
  10. Evaluate characteristics of the initial proposal
  11. Customize evaluation result graph
  12. Confirm torque and power of initial proposal
  13. Confirm inductance
  14. Run parametric analysis of current phase
  15. Compare results
  16. Run parametric analysis of gap length
  17. Compare results
  18. Select improvement plan
  19. Adjust drive conditions and evaluate
  20. Displaying the Results
  21. Enclosure
<< Prev Next >>
65 deg for current phase and 0.85 mm for gap length are chosen from the results obtained at this stage, and evaluation will continue.
Select only the check boxes of relevant cases in the above table and click [Apply Selected Case].