DP
Transient Magnetic (2D/Axisymmetric)
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JFT094] Parametric Analysis of Material Properties
In this document a parametric analysis is carried out varying coefficients for an iron loss equation from case to case, and a procedure for obtaining Joule loss and hysteresis los…
-
[JFT096] Performing Parametric Analysis Using an Analysis Parameter View
In this document, how to perform parametric analysis using an analysis parameter view and how to check the results is presented.
-
[JFT104] Application of an Anomalous Eddy Current Loss Factor Dependent on Magnetic Flux Density and Frequency
In this document, an anomalous eddy current loss factor table is created in which an anomalous eddy current loss correction factor is dependent on frequency and magnetic flux dens…
-
[JFT113] Running Calculations by Grouping Multiple Jobs Using SSH
JMAG is capable of grouping multiple jobs and registering them to the job management system.
-
[JFT123] Accounting for Residual Strain
This document explains the procedure for executing magnetic field analysis and iron loss analysis that account for residual strain.
-
[JFT133] System Loss Evaluations in System-Level Simulations
This document describes the method to output an efficiency map / loss map obtained with JMAG and using a circuit simulation to comprehend drive cycle system loss.
-
[JFT078] Stopping an Analysis Automatically After Reaching Steady-State
In this document, how to automatically stop analysis after steady-state is reached is presented.
-
[JAC259] Automatically Searching for Current Phase that Obtains Maximum Torque and Evaluating Torque Characteristics
In this example, the current phase that maximizes the torque is searched for each of three rotor geometries. The motor average currents and torque ripples are evaluated using the …
-
Introduction of New Coils (AST COIL) Using Motor Analysis Developed with Proprietary Manufacturing Methods
Kyohei Yanagisawa, ASTER CO., LTD.
-
[JFT149] How to Create JMAG-RT Model with JMAG Designer and Run Consecutive Control Simulation
This document explains the procedure on how to create a JMAG-RT model in JMAG-Designer and how to use the created model to run consecutive control simulation.
-
[JFT153] Topology Optimization Calculations Using CNN Surrogate Models
This document describes as the workflow for topology optimization calculations using CNN surrogate models running topology optimization for creating a CNN surrogate model, creatin…
-
[JFT136] Sending SSH Settings to Remote Machines
This document describes the method for sending SSH settings configured on local machines to remote machines for executing other case calculations.
-
[JAC157] Analysis of Eddy Currents in an IPM Motor Using the Gap Flux Boundary
This Application Note explains how to use the gap flux boundary condition to evaluate the eddy current loss in the magnet by changing the number of magnet divisions. This will mak…
-
[JFT138] Creating Vector Expression Data and Using Vector Expressions
This document describes creating vector expression data prior to executing analysis, and the method for creating vector expressions based on that information.
-
[JFT098] Automatic Thread Allocation During Local Job Execution
In this document, how to optimally allocate threads to cores is presented.
-
[JFT126] Vectorizing Signals in a Control Circuit (MUX, DEMUX)
This document describes the methods for using a signal vectorization component (MUX) and vector disassembling component (DEMUX) in a control circuit.
