[JFT122] Executing Optimization Calculations Using Reduced Order Models

This document describes the method for executing simple analysis and optimization using a reduced order model.

• Technical Themes: Design Exploration / Optimization and Efficiency map

[JFT142] Creating Shapes Using a Local Coordinate System

This document describes the method for using local coordinate systems to create shapes and changing the shapes parametrically.

[JFT131] Evaluating Degrees of Similarity for Geometry Using NGnet Weight

This document describes a method where after executing topology optimization using NGnet, degrees of similarity for geometry from NGnet weight are evaluated.

• Technical Themes: Design Exploration / Optimization

[JFT125] Inheriting Operating Points Between Modes in Efficiency Map Studies

This document describes the method for using operating point information obtained with speed priority mode in accuracy priority mode.

• Technical Themes: Design Exploration / Optimization, Efficiency map, and MBD

[JAC275] IPM Motor Iron Loss Analysis Accounting for the Effect of Residual Strain

In this document, an analysis of an IPM motor accounting for the residual strain that occurs as a result of punching processes, and evaluates the effect on torque, magnetic flux d…

• Applications: IPM Motor and Motor
• Physical Phenomena: Magnetic Field

[JFT135] Distributed Execution of Topology Optimization Calculation Using SSH

This document describes how to perform topology optimization calculations with the on/off method on a Linux remote machine via SSH.

• Technical Themes: Design Exploration / Optimization

[JFT150] Running Calculations of Multiple Studies Connected on Circuits

This documents explains the procedures on how to run analysis of multiple FEM analysis connected on circuits in JMAG-Designer.

[JAC074] Speed Versus Torque Analysis of a Single-Phase Induction Motor

This Application Note explains how to obtain the current density distribution and Speed-Torque curve created by auxiliary winding that uses a capacitor.

• Applications: Induction Motor and Motor
• Physical Phenomena: Magnetic Field

[JFT148] How to Set an Electrical Component for Each Wire Using Winding Editor

In this document, the difference in the connection status of the circuit wire by selecting/clearing in the optional function of Winding Editor is checked.

[JAC040] Cogging Torque Analysis of an SPM Motor

This Application Note presents the use of magnetic field analysis to obtain the cogging torque of an 8-pole, 9-slot SPM motor, which has relatively small period.

• Applications: Motor and SPM Motor
• Physical Phenomena: Magnetic Field

[JAC167] Iron Loss Analysis of a Three Phase Induction Motor

This Application Note presents an example of how to find the iron loss in the stator core and rotor core at a rotation speed of 3,300 r/min.

• Applications: Induction Motor and Motor
• Physical Phenomena: Magnetic Field

[JAC286] IPM Motor Iron Loss Analysis Accounting for PWM -Evaluation with Different Modulation Methods-

In this example, the effects on iron loss when the modulation method for PWM control is changed are evaluated.

• Applications: IPM Motor and Motor
• Physical Phenomena: Magnetic Field

[JAC091] Iron Loss Analysis of an IPM Motor Including the Effects of Press Fitting Stress

This Application Note presents modeling the press fitting of a core and frame with the Press Fit condition and then obtaining the iron loss density of an IPM motor with and withou…

• Applications: IPM Motor and Motor
• Physical Phenomena: Magnetic Field and Structural
• Technical Themes: Multiphysics

[JFT157] How to Output the Physical Quantities of Multiple Cases to Files in Batches by Using the Multi-Purpose File Export Tool

This document describes how to output the physical quantities of multiple cases in batches by using the Multi-Purpose File Export tool.

• Technical Themes: MBD and Multiphysics

[JFT156] Creating Shapes Using NGnet Weight

This document describes how to restore only the necessary shapes from NGnet weight after running topology optimization using NGnet.

• Technical Themes: Design Exploration / Optimization

[JFT180] Topology Optimization Including Magnet Orientation Directions as Design Variables

This document describes the procedures for running topology optimization, including the magnet orientation directions as design variables.