DP
Transient Magnetic (2D/Axisymmetric)
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC173] Basic Characteristic Analysis of an IPM Motor
This Application Note demonstrates an analysis in which an IPM motor's cogging torque, torque, magnetic flux density distribution, and iron loss in the stator core are obtained.
-
[JAC082] Analysis of a Synchronous Reluctance Motor
This Application Note presents an evaluation of torque variations that occur when the phase of a sinusoidal wave current is changed.
-
[JAC120] Thermal Demagnetization Analysis of an SPM Motor
This Application Note presents how to change the temperature of permanent magnets in an analysis, and then evaluate the effects on the torque waveform, magnetic flux density distr…
-
[JAC162] Drive Simulation of an SR Motor using a Control Simulator and JMAG-RT
In this Application Note, after using JMAG-RT to obtain an SR motor’s torque and inductance characteristics, the JMAG-RT model is imported into a circuit/control simulator, voltag…
-
[JAC038] Starting Performance Analysis of a Single Phase Induction Motor
The purpose of this Application Note is to introduce an example of a single phase induction motor that uses a capacitor to set up an auxiliary winding and show its rotation speed …
-
[JAC177] Torque Characteristic Analysis of a Three Phase Induction Motor
This Application Note explains how to obtain the torque characteristics in an induction motor when the current amplitude has been changed in a specific slip.
-
[JAC252] Geometry Optimization of a Solenoid Valve
In this example, an example where the geometry of a solenoid valve is optimized using a multi-objective optimization algorithm is presented.
-
[JAC115] Eccentricity Analysis of an SPM Motor
This Application Note presents how to evaluate the cogging torque waveform and effects on the electromagnetic force acting on the stator in an SPM motor with and without eccentric…
-
[JAC106] Iron Loss Analysis of a Brush Motor
This note presents how to obtain the iron loss in the stator core and rotor core of a brush motor.
-
[JAC244] Magnetic Field Strength Analysis at a Sensor Position
In this example, with the analysis target being a motor and the detection sensor being a TMR sensor, an example where a detection signal waveform is obtained that is based on magn…
-
[JAC257] IPM Motor Topology Optimization
In this example, rotor core maximum stress and radial direction maximum displacement in the radial direction are set to certain values or less, and rotor geometry is designed that…
-
[JAC243] Voice Coil Motor Control Simulation Using a Control Simulator and JMAG-RT
In this example, circuit simulation is performed to control the position of a mover by loading a JMAG-RT model for a voice coil motor into a control/circuit simulator.
-
[JAC195] Torque characteristics analysis of three-phase induction motors using 3D correction function
This document introduces introduces a case study which obtains inductance correction values, and then obtains N-T characteristics (revolution speed-torque characteristics) using t…
-
[JAC231] Vector Control Simulation of a Synchronous Reluctance Motor
In this example, circuit simulation is carried out simulating the control of current and speed by loading a JMAG-RT model for a SynRM into a control/circuit simulator. In addition…
-
[JAC069] Iron Loss Analysis of an IPM Motor
This Application Note explains a case example that obtains the iron loss and its distribution in a permanent magnet motor.
-
[JAC142] Press Fit Analysis of a Divided Core
This Application Note presents how to use the Press Fit condition to model an analysis of the stress from fitting a core to a frame, and then obtain the iron loss density of an IP…
