[JFT042] A Method for Obtaining a Steady-State Solution at an Early Stage (Time Periodic Explicit Error Correction)

In this document, obtaining steady-state in less time steps using TP-EEC function will be presented.

[JFT050] Procedure for Exporting a Selected Study from a Project

In this document, the procedure for exporting 1 study is presented.

[JFT053] Magnet Magnetization Direction Inheritance Using an Analysis Template

In this document, the method for inheriting the magnetization direction of a magnet using an analysis template is detailed.

[JFT051] Creating and Using Geometry Templates

In this document, the procedure for registering geometry and using the registered geometry is described.

[JFT052] Creating a Motor Geometry Using a Geometry Template

In this document, how to create a motor geometry using pre-installed stator and rotor geometries is presented.

[JFT046] Analysis Group Inheritance Using an Analysis Template

In this document, how to set analysis groups using an analysis template is explained.

• Technical Themes: Multiphysics

[JFT048] Brush / Commutator Component

In this document, how to use the Brush / Commutator component is described.

[JFT044] Pre-Post and Solver Parallel Distributed Processing Using SSH

In this document, how to set pre-post and solver parallel distributed processing is explained.

[W-MA-49] Necessity and Approach of Stray Load Loss Analysis

The main components of loss depend on the operating point. One of these components is stray load loss.

• Applications: IPM Motor and Motor
• Physical Phenomena: Magnetic Field
• Technical Themes: Large-Scale Processing

[JFT030] Procedure for Adding Cases with a Dimension as a Design Parameter (Parametric Analysis)

This document shows the procedure to set a dimension as a design parameter in advance preparation.

• Technical Themes: Design Exploration / Optimization

[JFT033] Eccentricity Setting for Parallelly Moving the Motion Region Initial Location

This document shows how to set the eccentricity to account for the moving part’s axis remaining parallel to the central axis while moving from the initial position and afterwards.

[JFT028] Procedure for Adding Cases Using Materials (Parametric Analysis)

This document shows the procedure of advance preparation using materials.

• Technical Themes: Design Exploration / Optimization

[JFT023] Frequency Component Analysis of Distributions Obtained by Transient Response Analysis

This document shows how to display output results ij vector form using the Fourier transform calculation function.

[JFT027] Procedure for Adding Cases Using Equations (Parametric Analysis)

This document shows the procedure of advance preparation using select parameters.

• Technical Themes: Design Exploration / Optimization

[JFT016] Controlling Mesh Generation Method for Each Part

This document describes how to control the mesh generation method for each part by using the extruded direction function.

[JFT034] Eccentricity Setting for Parallelly Offsetting the Rotation Axis

This document shows setting to move the rotation axis in parallel.