JMAG Script Library
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[D0009] Recommended settings for 3D FEM conductor conditions
Apply recommended settings for 3D FEM conductor conditions.
-
[D0016] Extract anomalous eddy current loss coefficient
Make anomalous eddy current loss coefficient table from a Custom material.
-
[D0032] Setup study for transfer function creation
Set up a frequency analysis study for transfer function creation.
-
[D0037] Set Cooling (Forced Convection)
Set Cooling by Forced Convection
-
[D0004] Set the coil material
Sets the material for parts in the current study named "Coil" to copper.
-
[D0014] Calculate Efficiency from Drive Mode
Uses results of the efficiency map analysis study to calculate efficiency of electric vehicles in a specified drive mode.
-
[D0028] Search Size Range in Optimization Table
Search for the maximum value and the minimum value of the parametric variable range of optimization.
-
[D0007] Electrostatic Capacitance Coefficient Calculation
Outputs the capacitance coefficient of a system consisting of multiple conductors in CSV file format.
-
[D0030] Allow Eddy Current for selected parts
This script sets the "Allow Eddy Current" flag for selected parts.
-
[S8447] Script to add a case with modified design parameters including geometry dimensions.
I want to add a case and change design parameters including geometry dimensions with a script.
-
[S8441] Script for performing FFT on torque waveforms and extracting the maximum amplitude from each frequency component
The following is an example of a script that performs FFT on torque waveforms and extracts the maximum amplitude from each frequency component.
-
[S8493] Script to calculate the induced voltage constant Ke from the analysis results and register it in the response value
The following is an example of a script that calculates the induced voltage constant Ke from the analysis results and registers it in the response value.
-
[S8369] Script for performing Boolean operations by specifying part names in the Geometry Editor
The following is an example of a script that performs Boolean operations on specified parts using the Geometry Editor.
-
[S9390] Script for setting the switching timing of the PAM inverter
The following is an example of a script for setting the switching timing of a PAM inverter.
-
[S8401] Script for specifying parts by coordinates and setting conditions
The following is an example of a script that specifies parts by coordinates and sets conditions.
-
[S8626] Script for setting skin depth based on material and frequency
The following is an example of a script for setting the skin depth based on material and frequency.
