[JFT016] Controlling Mesh Generation Method for Each Part

This document describes how to control the mesh generation method for each part by using the extruded direction function.

[JFT034] Eccentricity Setting for Parallelly Offsetting the Rotation Axis

This document shows setting to move the rotation axis in parallel.

[JFT014] Physical Amount Calculation for Any Cross Section

This document shows how to define any cross section, using that defined cross section and settings to calculate physical amounts, and how to confirm results.

[JFT027] Procedure for Adding Cases Using Equations (Parametric Analysis)

DownloadVersionSize (KB)Guide (PDF) -436Sample Data JMAG-Designer 17.096Case

[JFT039] Procedure for Removing Overlapping Sections of Two Parts

In this document, the procedure for removing the overlapping sections of two solids is described.

[JFT035] Eccentricity Setting for Inclining the Motion Region Axis

This document shows setting to tilt the motion region axis.

[JFT022] File Export of a Physical Quantity by Multi-Purpose File Export Tool

This document shows how to export one physical quantity from JMAG using a multi-purpose file export tool.

• Technical Themes: MBD and Multiphysics

[JFT041] Simple Skew Analysis Using Results Data

In this document, how to use the skew graph function is described.

[JFT016] Controlling Mesh Generation Method for Each Part

DownloadVersionSize (KB)Guide (PDF) -337Sample Data JMAG-Designer 17.068Case

[JFT031] Procedure for Adding Dimension Cases Using Equations (Parametric Analysis)

DownloadVersionSize (KB)Guide (PDF) -474Sample Data JMAG-Designer 17.016Case

[JFT020] Inheritance of Analysis Content by Analysis Template

This document shows how to inherit conditions and materials using an analysis template.

[JFT029] Procedure for Adding Cases Using Point Sequences (Parametric Analysis)

This document shows the procedure of advance preparation using point sequences.

• Technical Themes: Design Exploration / Optimization

[JFT112] Defining Response Values with Scripts in Topology Optimization Using NGnet

In this document, response values are calculated using a Python script, and a method for performing topology optimization used as an objective function is described.

• Technical Themes: Design Exploration / Optimization

[JFT040] Creating Specified Outputs Using Distribution Results

DownloadVersionSize (KB)Guide (PDF) -356Sample Data JMAG-Designer 17.064Case

[JFT019] Setting an FEM Conductor Condition for a Set of Parts

This document describes how to set the FEM conductor conditions collectively for many wires using a script pre-installed in JMAG.

[JFT040] Creating Specified Outputs Using Distribution Results

In this document, how to define an expression of an output and how to display its contour plot is described.