Study

[S0012] Get the analysis results in table format

Get analysis results in table format, including units. For transient response analysis, also get a step time.

[S0011] Apply heat transfer boundary condition to the part surfaces

In a thermal analysis study, apply heat transfer boundary condition to the faces defined by the set.

[S0010] Set up the automatic meshing property with Method 3: Automatic element size

Set the mesh properties for the 2D magnetic field analysis to slide mesh method 3 (automatic element size).

[S0009] Add result calculation of parts, faces, or edges for mesh groups

Create result calculation definition of part, face or edge that target mesh groups.

[S0008] Get the applied conditions by specifying the analysis condition type name

Retrieve the conditions applied to the study by specifying the type name of the analysis condition. This method does not use the title or index of the condition.

[S0005] Set the orientation pattern of the magnetization material parts to a parallel pattern (circular any direction)

In a magnetic field analysis, set the orientation pattern to a parallel pattern (circular any direction) in the properties of the part with the magnetization material

[S0004] Add steady conditions to the step control in the study properties of a magnetic field transient analysis

In a magnetic field transient analysis, add steady conditions to the step control to stop the analysis when a steady state is reached.

[S0003] Place a PWM 120deg conduction system (3-phase) component in the circuit

Place a PWM 120deg conduction system (3-phase) macro component in the circuit of a magnetic field transient analysis study or an integration analysis study

[S0002] Set the rotation motion condition to all parts within a specified radius from the origin

In the model of a magnetic field analysis study, set the rotation motion condition to parts within a specified radius from the origin

[S0001] In 2D magnetic field analysis, set the rotation periodic boundary condition to all edges on the X axis

In 2D magnetic field analysis model, set the periodic boundary condition to all edges on the X axis where X>=0

[D0005] All case create mesh

Create mesh for all cases if the case does not have a mesh.

[D0004] Set the coil material

Sets the material for parts in the current study named "Coil" to copper.

[D0003] Add current condition to coils

Set a current condition on all parts named "Coil" in the current study.

[D0002] Run all studies

Run all studies in the project.

[D0001] Add magnetic field strength contour

Add magnetic field strength contour definition to the current study.