[JFT069] Performing Harmonic Loss Calculations Accounting for Current Control with JMAG-Designer and JMAG-RT

In this document, how to calculate the harmonic loss of a current controlled (PWM controlled) PM motor at high speed using a JMAG-RT model is presented.

• Technical Themes: Material Modeling / Loss Analysis and MBD

[JFT053] Magnet Magnetization Direction Inheritance Using an Analysis Template

DownloadVersionSize (KB)Guide (PDF) -364Sample Data JMAG-Designer 17.168Case

[JFT048] Brush / Commutator Component

DownloadVersionSize (KB)Guide (PDF) -269Sample Data JMAG-Designer 17.1347Case

[JFT049] Grouping FEM Coil Conditions

In this document, how to group FEM coil conditions and associate them with macro component wave windings is explained.

[JFT042] A Method for Obtaining a Steady-State Solution at an Early Stage (Time Periodic Explicit Error Correction)

In this document, obtaining steady-state in less time steps using TP-EEC function will be presented.

[JFT044] Pre-Post and Solver Parallel Distributed Processing Using SSH

DownloadVersionSize (KB)Guide (PDF) -389Sample Data JMAG-Designer 17.11,140Case

[JFT051] Creating and Using Geometry Templates

DownloadVersionSize (KB)Guide (PDF) -324Sample Data JMAG-Designer 17.128Case

[JFT050] Procedure for Exporting a Selected Study from a Project

In this document, the procedure for exporting 1 study is presented.

[JFT046] Analysis Group Inheritance Using an Analysis Template

DownloadVersionSize (KB)Guide (PDF) -401Sample Data JMAG-Designer 17.1182Case

[JFT052] Creating a Motor Geometry Using a Geometry Template

DownloadVersionSize (KB)Guide (PDF) -274Case

[JFT053] Magnet Magnetization Direction Inheritance Using an Analysis Template

In this document, the method for inheriting the magnetization direction of a magnet using an analysis template is detailed.

[JFT049] Grouping FEM Coil Conditions

DownloadVersionSize (KB)Guide (PDF) -267Sample Data JMAG-Designer 17.1353Case

[JFT050] Procedure for Exporting a Selected Study from a Project

DownloadVersionSize (KB)Guide (PDF) -285Sample Data JMAG-Designer 17.1123Case

[JFT051] Creating and Using Geometry Templates

In this document, the procedure for registering geometry and using the registered geometry is described.

[JFT052] Creating a Motor Geometry Using a Geometry Template

In this document, how to create a motor geometry using pre-installed stator and rotor geometries is presented.

[JFT046] Analysis Group Inheritance Using an Analysis Template

In this document, how to set analysis groups using an analysis template is explained.

• Technical Themes: Multiphysics