[JAC290] Design Exploration of IPM Motors, Including Evaluating Part Temperature and Stress

In this example, the part temperature and stress are evaluated at the same time for the motor design plan, and a design plan that meets the requirements is explored.

• Applications: IPM Motor and Motor
• Physical Phenomena: Electric Field, Magnetic Field, Structural, and Thermal
• Technical Themes: Efficiency map and Multiphysics

[JAC297] Geometry Optimization of a Wound-field Synchronous Motor Including Efficiency Map, Part Temperature, and Stress Evaluations

This case study runs a parametric optimization of a main automotive engine to maximize efficiency and torque while minimizing the temperature and stress as constraint conditions.

• Applications: Motor and Wound-Field Synchronous Motor
• Physical Phenomena: Magnetic Field, Structural, and Thermal
• Technical Themes: Design Exploration / Optimization, Efficiency map, and Multiphysics

[JAC294] Design Exploration of Wound-Field Synchronous Motors, Including Evaluating Part Temperature and Stress

In this example, the efficiency map, part temperature, and stress, are evaluated at the same time for the motor design plan, and a design plan that meets the requirements is explo…

• Applications: Motor and Wound-Field Synchronous Motor
• Physical Phenomena: Magnetic Field, Structural, and Thermal
• Technical Themes: Efficiency map and Multiphysics

[JFT185] Using User Geometry in JMAG-Express (Ver.23.0 and later)

This document describes the procedures to let you run performance evaluations in JMAG-Express by using geometry created with external CAD.

[JAC279] Thermal Analysis Accounting for Cooling of the IPM Motor

In this example, thermal equivalent circuit is used to run thermal analysis of a 3-phase IPM motor that accounts for cooling, and check the temperature change in the coil.

• Applications: IPM Motor and Motor
• Physical Phenomena: Thermal

[JFT181] Using 2D CAD Data for Motor Design in JMAG-Express (Ver.22.1 and later)

This document describes the procedures for evaluating performance with JMAG-Express using geometry created from external CAD.

[JFT182] Using User Geometry in JMAG-Express

This document describes the procedures to let you run performance evaluation in JMAG-Express by using geometry created with external CAD.

[JFT166] Building Analysis Models with User-Defined Geometry and Thermal Design Scenarios

This document explains how to load user defined 2D models and build thermal analysis models.

• Technical Themes: Design Exploration / Optimization