JMAG-Designer
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JFT052] Creating a Motor Geometry Using a Geometry Template
In this document, how to create a motor geometry using pre-installed stator and rotor geometries is presented.
-
[JFT046] Analysis Group Inheritance Using an Analysis Template
In this document, how to set analysis groups using an analysis template is explained.
-
[JFT048] Brush / Commutator Component
In this document, how to use the Brush / Commutator component is described.
-
[JFT044] Pre-Post and Solver Parallel Distributed Processing Using SSH
In this document, how to set pre-post and solver parallel distributed processing is explained.
-
[W-MA-49] Necessity and Approach of Stray Load Loss Analysis
The main components of loss depend on the operating point. One of these components is stray load loss.
-
[JFT030] Procedure for Adding Cases with a Dimension as a Design Parameter (Parametric Analysis)
This document shows the procedure to set a dimension as a design parameter in advance preparation.
-
[JFT033] Eccentricity Setting for Parallelly Moving the Motion Region Initial Location
This document shows how to set the eccentricity to account for the moving part’s axis remaining parallel to the central axis while moving from the initial position and afterwards.
-
[JFT028] Procedure for Adding Cases Using Materials (Parametric Analysis)
This document shows the procedure of advance preparation using materials.
-
[JFT023] Frequency Component Analysis of Distributions Obtained by Transient Response Analysis
This document shows how to display output results ij vector form using the Fourier transform calculation function.
-
[JFT027] Procedure for Adding Cases Using Equations (Parametric Analysis)
This document shows the procedure of advance preparation using select parameters.
-
[JFT016] Controlling Mesh Generation Method for Each Part
This document describes how to control the mesh generation method for each part by using the extruded direction function.
-
[JFT034] Eccentricity Setting for Parallelly Offsetting the Rotation Axis
This document shows setting to move the rotation axis in parallel.
-
[JFT014] Physical Amount Calculation for Any Cross Section
This document shows how to define any cross section, using that defined cross section and settings to calculate physical amounts, and how to confirm results.
-
[JFT035] Eccentricity Setting for Inclining the Motion Region Axis
This document shows setting to tilt the motion region axis.
-
[JFT039] Procedure for Removing Overlapping Sections of Two Parts
In this document, the procedure for removing the overlapping sections of two solids is described.
-
[JFT022] File Export of a Physical Quantity by Multi-Purpose File Export Tool
This document shows how to export one physical quantity from JMAG using a multi-purpose file export tool.