[JFT139] Coil Modeling for Axial Gap Type Rotating Machines Using Coil Template and Winding Editor

This document explains how to create coil shapes and set conditions for an axial gap type motor.

[JFT139] Coil Modeling for Axial Gap Type Rotating Machines Using Coil Template and Winding Editor

DATAFile nameSize (KB)GuideJFT139CoilTemplateAddAxial-e.pdf1,401Sample DataJMAG-Designer 20.2JFT139CoilTemplateAddAxial.zip173Case

[JFT120] The Symmetric Hysteresis Loop Creation Function for Play Models

This document describes the method for creating groups of symmetric hysteresis loops by using tools from the measurement data of a single BH loop.

[JFT120] The Symmetric Hysteresis Loop Creation Function for Play Models

DATAFile nameSize (KB)GuideJFT120PlayBH-e.pdf395Sample DataJMAG-Designer 20.0JFT120PlayBH.zip1Case

[JFT142] Creating Shapes Using a Local Coordinate System

DATAFile nameSize (KB)GuideJFT142LocalCoordinate-e.pdf322Sample DataJMAG-Designer 20.2JFT142LocalCoordinate.zip72Case

[JFT142] Creating Shapes Using a Local Coordinate System

This document describes the method for using local coordinate systems to create shapes and changing the shapes parametrically.

[JFT135] Distributed Execution of Topology Optimization Calculation Using SSH

DATAFile nameSize (KB)GuideJFT135TopologyOptimizationSSH-e.pdf465Sample DataJMAG-Designer 20.0JFT135TopologyOptimizationSSH.zip140Case

[JFT135] Distributed Execution of Topology Optimization Calculation Using SSH

This document describes how to perform topology optimization calculations with the on/off method on a Linux remote machine via SSH.

• Technical Themes: Design Exploration / Optimization

[JFT147] Creating a Lookup Table Using Parametric Analysis

DownloadVersionSize (KB)Guide (PDF) -282Sample Data JMAG-Designer 20.2MATLAB 2020a256Case

[JFT147] Creating a Lookup Table Using Parametric Analysis

This document explains how to run parametric analysis in JMAG-Designer and register it as a lookup table for MATLAB.

[JFT141] JMAG-RT Model Data File Creation Function in JMAG-Designer

DATAFile nameSize (KB)Guide/JFT141CreateRTEmapFunction-e.pdf344Sample DataJMAG-Designer 20.2JFT141CreateRTEmapFunction.zip5,113Case

[JFT145] How to Arrange Windings That Are in Parallel Circuits on Specified Layers

DATAFile nameSize (KB)GuideJFT145WindingEditorParallel-e.pdf469Sample DataJMAG-Designer 20.2JFT145WindingEditorParallel.zip684Case

[JFT144] Flux Linkage Calculations in a Specified Position

DownloadVersionSize (KB)Guide (PDF) -296Sample Data JMAG-Designer 20.24,650Case

[JFT137] Current Restraints using Conditional Branches of Equation

DATAFile nameSize (KB)GuideJFT137ConditionalBranche-e.pdf262Sample DataJMAG-Designer 20.2JFT137ConditionalBranche.zip86Case

[JFT137] Current Restraints using Conditional Branches of Equation

This document explains how to restrain current value that is fed into the coils when geometry and electric resistance change.

[JFT144] Flux Linkage Calculations in a Specified Position

This document explains the procedure to set user-selected points in air regions and calculate flux linkage at these points.