Function Tutorials

[JFT147] Creating a Lookup Table Using Parametric Analysis

DownloadVersionSize (KB)Guide (PDF) -282Sample Data JMAG-Designer 20.2MATLAB 2020a256Case

[JFT147] Creating a Lookup Table Using Parametric Analysis

This document explains how to run parametric analysis in JMAG-Designer and register it as a lookup table for MATLAB.

[JFT141] JMAG-RT Model Data File Creation Function in JMAG-Designer

DATAFile nameSize (KB)Guide/JFT141CreateRTEmapFunction-e.pdf344Sample DataJMAG-Designer 20.2JFT141CreateRTEmapFunction.zip5,113Case

[JFT145] How to Arrange Windings That Are in Parallel Circuits on Specified Layers

DATAFile nameSize (KB)GuideJFT145WindingEditorParallel-e.pdf469Sample DataJMAG-Designer 20.2JFT145WindingEditorParallel.zip684Case

[JFT144] Flux Linkage Calculations in a Specified Position

DownloadVersionSize (KB)Guide (PDF) -296Sample Data JMAG-Designer 20.24,650Case

[JFT137] Current Restraints using Conditional Branches of Equation

DATAFile nameSize (KB)GuideJFT137ConditionalBranche-e.pdf262Sample DataJMAG-Designer 20.2JFT137ConditionalBranche.zip86Case

[JFT137] Current Restraints using Conditional Branches of Equation

This document explains how to restrain current value that is fed into the coils when geometry and electric resistance change.

[JFT144] Flux Linkage Calculations in a Specified Position

This document explains the procedure to set user-selected points in air regions and calculate flux linkage at these points.

[JFT141] JMAG-RT Model Data File Creation Function in JMAG-Designer

This document will show you how to export the efficiency map/loss map obtained in JMAG as a JMAG-RT model data file and to check the plot in JMAG RT-Viewer.

• Technical Themes: Efficiency Map

[JFT021] Setting Magnet Material with Coercive Force Distribution and Residual Magnetic Flux Distribution Considering Temperature Dependence

DATAFile nameSize (KB)GuideJFT021CoerciveForceDistributionMagnet-e.pdf387Sample DataJMAG-Designer 17.0JFT021CoerciveForceDistributionMagnet.zip64Case

[JFT145] How to Arrange Windings That Are in Parallel Circuits on Specified Layers

This document explains the procedure on how to set series-parallels of coils and switch the position in slots.

[JFT133] System Loss Evaluations in System-Level Simulations

This document describes the method to output an efficiency map / loss map obtained with JMAG and using a circuit simulation to comprehend drive cycle system loss.

• Technical Themes: Efficiency Map

[JFT127] Changing Settings for Parallel Computing When Executing Calculations

This document describes the procedure for changing settings for parallel computing when executing calculations.

[JFT128] Evaluating Drive Cycle Time Using Efficiency Maps

DATAFile nameSize (KB)GuideJFT128DriveMode-e.pdf443Sample DataJMAG-Designer 20.1JFT128DriveMode.zip2,877Case

[JFT131] Evaluating Degrees of Similarity for Geometry Using NGnet Weight

This document describes a method where after executing topology optimization using NGnet, degrees of similarity for geometry from NGnet weight are evaluated.

• Technical Themes: Design Exploration / Optimization

[JFT125] Inheriting Operating Points Between Modes in Efficiency Map Studies

This document describes the method for using operating point information obtained with speed priority mode in accuracy priority mode.

• Technical Themes: Design Exploration / Optimization, Efficiency Map, and MBD