Iron Loss Analysis / Loss Analysis
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC090] Analysis of the Effect of PWM on the Iron Loss of an IPM Motor
This Application Note demonstrates a case study where the effects of a carrier harmonic against an IPM motor’s iron loss is confirmed using estimated harmonic current waveform as …
-
Comparison between IPM and SPM based on Experiment and Analysis Result(Report of Harumi Project1)
Kan Akatsu,Katsuyuki Narita,Yoshuki Sakashita,Takashi Yamada, Tokyo University of Agriculture and Technology/JRI Solutions, Ltd.
-
Evaluation of eddy current characteristic for applied high frequency voltage to the giant magnetrostrictive material
Masayuki Sugasawa, Sony EMCS Corporation
-
Customized Development of Automotive Motor System using JMAG-Studio
Ryoma Matsuo, PUES Corporation
-
Numerical Magnetic Field Analysis in Electric Performance Calculation in Large Rotating Machines.
Kazumasa Ide, Hitachi, Ltd.
-
Introduction to the electromagnetic field analysis software for transformer design
Yusaku Suzuki, JRI Solutions, Ltd.
-
Demands for electromagnetic field analysis and problems specific to transformers
Shigekazu Sakabe, Tabuchi Electric Co.,Ltd.
-
[JAC031] Iron Loss Analysis of an SPM Motor Including the Effect of Press-fitting Stress
This note presents the use of the press fit condition to model a core and frame and obtains iron loss density for when the generated stress is used and not used.
-
[JAC029] Iron Loss Analysis of an SPM Motor with Overhanging Magnet
This Application Note presents the use of a no-load iron loss analysis of an SPM motor with and without an overhanging magnet.
-
Resent Progress of Non-oriented Electrical Steel and Measurement Techniques
H.Mogi, Nippon Steel Corporation
-
Analysis of Transformer using JMAG-Studio
Hidenori Uematsu, Panasonic Electronic Devices Co.,Ltd
-
Evaluation of Motors Using Powder Magnetic Cores by JMAG-Studio
Kinji Kanagawa, MITSUBISHI MATERIALS CORPORATION
-
[JAC021] Iron Loss Analysis of an SPM Motor Including the Effect of Shrink Fitting
This note presents an analysis to obtain the iron loss density of an SPM motor both including and not including the stress caused by shrink fitting.
-
200 KW PERMANENT MAGNET ALTERNATOR ANALYSIS & COMPARISON TO TEST RESULTS
James R Hendershot, Motorsoft Div & Fisher Electric Technology
-
Practical Use of Connected Electro-circuit Simulation with Electromagnetic Analysis in the Development of Robot Actuator
Takeo Kishida, Sony Corporation
-
Motor Core Iron Loss Analysis Evaluating Shrink Fit and Stamping Effect
Keisuke Fujisaki, Nippon Steel Corporation
