Parametric Analysis / Optimization
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JFT031] Procedure for Adding Dimension Cases Using Equations (Parametric Analysis)
This document shows the procedure of advance preparation using an equation for dimensions.
-
[JFT032] Evaluation Graph Displaying for Design Parameters (Parametric Analysis)
This document describes the procedure for setting response data and the procedure for generating response graphs from response data.
-
[JFT163] How to Output the Input Files for the Calculation of Multiple Cases at a High Speed
This document describes how to output the input files for calculations with changes made to the input conditions.
-
[JFT159] How to Create Motor Design Using Models & Scenarios
This enables you to create motor models, run analysis and evaluate the results in fewer steps. This document explains the procedure on how to create models using the templates and…
-
[JFT026] Procedure for Adding Cases Using Select Parameters (Parametric Analysis)
This document shows the procedure of advance preparation using select parameters.
-
[JFT156] Creating Shapes Using NGnet Weight
This document describes how to restore only the necessary shapes from NGnet weight after running topology optimization using NGnet.
-
[JFT103] Performing Topology Optimization Using Density Method
In this document, how to execute topology optimization using sensitivity analysis using JMAG is presented.
-
[JFT065] Obtaining Part Face Area and How to Set Conditions
This document explains how to set current values for a coil area.
-
[JFT097] Optimization Execution Using Material Characteristics as Design Variables
In this document, how to perform optimization with material characteristics used as design variables is presented.
-
[JFT135] Distributed Execution of Topology Optimization Calculation Using SSH
This document describes how to perform topology optimization calculations with the on/off method on a Linux remote machine via SSH.
-
[JFT131] Evaluating Degrees of Similarity for Geometry Using NGnet Weight
This document describes a method where after executing topology optimization using NGnet, degrees of similarity for geometry from NGnet weight are evaluated.
-
[JFT136] Sending SSH Settings to Remote Machines
This document describes the method for sending SSH settings configured on local machines to remote machines for executing other case calculations.
-
[JFT118] Distributed Processing for Parameter Optimization Calculations Using SSH
This document describes a method for running optimization calculations with a Linux remote machine by using SSH.
-
[JFT096] Performing Parametric Analysis Using an Analysis Parameter View
In this document, how to perform parametric analysis using an analysis parameter view and how to check the results is presented.
-
[JFT057] How to Run Topology Optimization
This document describes how to run topology optimization using JMAG.
-
[JFT076] Methods for Running Geometry Optimization Using Multiple Studies
This document describes how to run geometry optimization using multiple studies.
