Search results

Sort condition
Newest first
Oldest first
Views
  1. 244 – Magnetic Field Strength Analysis at a Sensor Position

    In this example, with the analysis target being a motor and the detection sensor being a TMR sensor, an example where a detection signal waveform is obtained that is based on magn…

  2. 240 – NT Characteristics Analysis of an IPM Motor Using PAM Drive

    In this example, an example of evaluating the performance of an IPM with PAM operation is presented.

  3. 251 – Alternator Vibration Analysis

    In this example, the electromagnetic force generated in the stator core of a claw pole alternator is obtained, and acceleration is evaluated with an electromagnetic force - struct…

  4. 218 – High-Frequency Induction Hardening Analysis Accounting for Deformation

    In this example, using the JMAG magnetic field - thermal stress coupled analysis function, analysis is performed evaluating gear deformation from induction heat hardening.

  5. 255 – Evaluating the N-T Curve of an IPM motor Using 3D Correction

    In this example, obtains N-T curves using the correction function.

  6. 223 – Multi-Objective Optimization of IPM Motors Considering Stress at High Rotation

    In this example, presented where a rotor geometry is designed by a multi-objective genetic algorithm with objective functions for torque characteristics (5,000 r/min) and for the …

  7. 250 – Dielectric Heating Analysis of a High-Frequency Preheater with Roller Electrodes

    In this example, a use case is presented where the influence of the pitch of roller electrodes on the temperature distribution of a material (tablets) is evaluated.

  8. 220 – Analysis of the High-Frequency Induction Hardening and Cooling of a Gear

    In this example, deals with induction heating and cooling analysis. An example is presented where the cooling rate for a gear differs depending on the cooling conditions.

  9. 224 – Wireless Power Transfer Device Stray Loss Analysis

    In this example, an example is presented investigating by using electromagnetic field analysis whether stray loss can be suppressed using an aluminum shield.

  10. 219 – Axial Gap Motor Cogging Torque Analysis

    In this example, presents a case study to obtain the cogging torque in an axial flux motor.

  11. 254 – Vibration Analysis of Oil-Immersed Large Transformer

    This document introduces a case example of evaluating the vibrations of a large transformer. Parts that are usually the source of vibrations are the core, tank, and windings, but …

  12. 226 – Vibration Characteristics Analysis of SPM Motors

    In this example, the acceleration is evaluated by obtaining the electromagnetic force generated in the stator core of the SPM motor at multiple rotation speeds and coupling with t…

  13. 246 – Analysis of Electromagnetic Force Acting Between a Coil and a Magnet

    In this example, a use case in which the N-T-I characteristics for a single-phase synchronous motor are obtained is presented.

  14. 192 – Response Characteristics Analysis of Solenoid Valves Accounting for Residual Magnetization

    Here, we will discuss the steps to investigate the effect on responsiveness caused by residual magnetization generated in the magnetic materials, and look at case examples.

  15. 222 – Irreversible Thermal Demagnetization Analysis of Incompletely Magnetized Magnets

    In this example, analysis is performed while varying the temperature of magnetized magnets, and then the influence on the torque waveform and magnetic flux density distribution is…

  16. 214 – Monitoring the Radial Force Acting on the Teeth of IPM Motors Using Circuit Control Simulation

    In this example, an IPM motor as a JMAG-RT model is captured in a control/circuit simulator, and radial forces acting on the teeth during motor driving is monitored while changing…

Search Filter