Geometry
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JFT195] The Use of Custom Geometry in JMAG-Express Using Auto Constraint
This tutorial describes the procedures to use geometry modeled in an external CAD software and evaluate the performance in JMAG-Express.
-
[JFT052] Creating a Motor Geometry Using a Geometry Template
In this document, how to create a motor geometry using pre-installed stator and rotor geometries is presented.
-
[JFT001] Wire Modeling Using the Sweep Function
This tutorial describes the procedures to create three-dimensional geometry using the sweep function.
-
[JFT002] Parametric Analysis of Geometry Using Direct Modeling
This document describes the procedures necessary to run a parametric analysis of geometry using direct modeling.
-
[JFT116] Creating Rotating Machine Coil Geometry Accounting for Arbitrary Winding Methods
This document describes the method for creating a rotating machine coil using the coil template Edit Winding Table function.
-
[JFT168] Creating Geometry to Reduce Geometry Corruption
This document explains how to create geometry that is less likely to result in geometry corruption.
-
[JFT174] Workflow and Key Points of Parameter Optimization
This document is intended for intermediate-level readers who can use the technical materials to improve the accuracy and operational efficiency of the analyses that they are invol…
-
[JFT166] Building Analysis Models with User-Defined Geometry and Thermal Design Scenarios
This document explains how to load user defined 2D models and build thermal analysis models.
-
[JFT051] Creating and Using Geometry Templates
In this document, the procedure for registering geometry and using the registered geometry is described.
-
[JFT039] Procedure for Removing Overlapping Sections of Two Parts
In this document, the procedure for removing the overlapping sections of two solids is described.
-
[JFT062] Creating a Geometry Using a Geometry Template (Python)
In this document, how to create geometry templates using JMAG is described.
-
[JFT108] Creating a 3D Mesh Model from a 2D Mesh Model
In this document, how to create a 3D mesh model from a 2D mesh model using Geometry Editor is presented.
-
[JFT017] Geometry Creation Using Wire Template
This document shows how to create many wires at once using the wire template.
-
[JFT013] Create of a Truncated Pyramid Shape Using the Loft Function
This document describes how to create a 3D geometry by using the Loft function.
-
[JFT105] A CAD Link Function to 3D CAD Software NX
In this document, how to open an NX .prt file in JMAG-Designer and change dimensions is presented.
-
[JFT151] Coil Creating Method Using Beams
This document explains how to calculate using line current conditions in magnetic field analysis.
