[JFT039] Procedure for Removing Overlapping Sections of Two Parts

In this document, the procedure for removing the overlapping sections of two solids is described.

[JFT001] Path Creation Function and Sweep Function

This document contains sample data and the operation procedures for learning how to use the sweep function.Sweep is a function to push out the cross-section geometry along a path.

• Technical Themes: Large-Scale Processing

[JFT013] Create of a Truncated Pyramid Shape Using the Loft Function

This document describes how to create a 3D geometry by using the Loft function.

[JFT017] Geometry Creation Using Wire Template

This document shows how to create many wires at once using the wire template.

[JFT052] Creating a Motor Geometry Using a Geometry Template

In this document, how to create a motor geometry using pre-installed stator and rotor geometries is presented.

[JFT051] Creating and Using Geometry Templates

In this document, the procedure for registering geometry and using the registered geometry is described.

[JFT061] Creating Line Shapes Using Functions

In this document, a method to perform geometry creation automatically using JMAG is presented.

[JFT062] Creating a Geometry Using a Geometry Template (Python)

In this document, how to create geometry templates using JMAG is described.

[JFT105] A CAD Link Function to 3D CAD Software NX

In this document, how to open an NX .prt file in JMAG-Designer and change dimensions is presented.

• Technical Themes: Design Exploration / Optimization

[JFT018] Coil Geometry Creation of Rotating Machine Using Coil Template

This document describes the method for creating distributed winding coils using coil templates.

[JFT002] Geometry Parametric Analysis Using Direct Modeling

In this document, how to perform geometry parametric analysis using direct modeling is presented.

• Technical Themes: Design Exploration / Optimization

[JFT108] Creating a 3D Mesh Model from a 2D Mesh Model

In this document, how to create a 3D mesh model from a 2D mesh model using Geometry Editor is presented.

[JFT116] Creating Rotating Machine Coil Geometry Accounting for Arbitrary Winding Methods

This document describes the method for creating a rotating machine coil using the coil template Edit Winding Table function.