[JFT012] JMAG-RT Model Generation of Wound-Field Synchronous Motor

This document shows how to generate a JMAG-RT model of a wound-field synchronous motor and how to execute control simulation using a JMAG-RT model in MATLAB/Simulink.

• Technical Themes: MBD

[JFT047] Performing Harmonic Loss Calculations with Current Control in JMAG-Designer

In this document, how to calculate the harmonic loss of a current controlled (PWM controlled) motor is described.

• Technical Themes: Material Modeling / Loss Analysis

[JFT077] Creating JMAG-RT Models with Generic Circuit Topology

This document describes the method for creating plant models (JMAG-RT models) with generic circuit topology.

• Technical Themes: MBD

[JFT134] Inheritance Between Current Waveform Studies

This document describes the method for setting a current waveform obtained from a 2D analysis to a 3D analysis automatically by using a post calculation script.

[JFT110] Evaluating the Effect of the Large Number of Holes Generated by Topology Optimization

This document describes how to efficiently analyze the presence or absence of an effect on hole response values when a large number of holes are generated as a result of topology …

[JFT069] Performing Harmonic Loss Calculations Accounting for Current Control with JMAG-Designer and JMAG-RT

In this document, how to calculate the harmonic loss of a current controlled (PWM controlled) PM motor at high speed using a JMAG-RT model is presented.

• Technical Themes: Material Modeling / Loss Analysis and MBD

[JFT049] Grouping FEM Coil Conditions

In this document, how to group FEM coil conditions and associate them with macro component wave windings is explained.

[JFT042] A Method for Obtaining a Steady-State Solution at an Early Stage (Time Periodic Explicit Error Correction)

In this document, obtaining steady-state in less time steps using TP-EEC function will be presented.

[JFT048] Brush / Commutator Component

In this document, how to use the Brush / Commutator component is described.

[JFT044] Pre-Post and Solver Parallel Distributed Processing Using SSH

In this document, how to set pre-post and solver parallel distributed processing is explained.

[JFT023] Frequency Component Analysis of Distributions Obtained by Transient Response Analysis

This document shows how to display output results ij vector form using the Fourier transform calculation function.

[JFT027] Procedure for Adding Cases Using Equations (Parametric Analysis)

This document shows the procedure of advance preparation using select parameters.

• Technical Themes: Design Exploration / Optimization

[JFT041] Simple Skew Analysis Using Results Data

In this document, how to use the skew graph function is described.

[JFT029] Procedure for Adding Cases Using Point Sequences (Parametric Analysis)

This document shows the procedure of advance preparation using point sequences.

• Technical Themes: Design Exploration / Optimization

[JFT112] Defining Response Values with Scripts in Topology Optimization Using NGnet

In this document, response values are calculated using a Python script, and a method for performing topology optimization used as an objective function is described.

• Technical Themes: Design Exploration / Optimization

[JFT003] Evaluation of Hysteresis Loops and Loss Density Distributions inside an Electromagnetic Steel Sheet

In this document, the procedure for evaluating iron loss distribution for the thickness direction of steel sheets is presented.

• Technical Themes: Material Modeling / Loss Analysis