JMAG-Designer

Sort condition
Newest first
Oldest first
Large number of views
  1. [JAC206] Temperature Analysis of an Oil-Immersed Transformer Using a Coupled Magnetic Field and Thermal Fluid Analysis

    This document introduces, examples and steps will be shown to obtain heat distribution in a magnetic field analysis for a forced circulation type oil-immersed transformer, map the…

  2. [JAC191] Torque Analysis of Three-Phase Induction Motors Accounting for the Skew Using the Multi-slice Method

    In this document, the multi-slice method is used to compare torque waveforms of a cage three-phase induction motor with and without skew, and is then used to verify the effects of…

  3. [JAC198] Bus Bar Thermal Stress Analysis

    Here, temperature distributions for bus bars are obtained when the power supply frequency is changed.

  4. [JAC189] Response Characteristics Analysis of Injectors Accounting for Collision

    For this case, direct current voltage is applied to the solenoid type injector and the response characteristics is obtained after accounting for the effect of the collision and ed…

  5. [JAC188] Thermal Demagnetization Analysis of IPM Motors Accounting for Coercive Force Distribution of Magnets

    This example presents whether or not the demagnetization region can be smaller by assigning distribution to the coercive force of permanent magnets.

  6. [JAC185] Analysis of Stray Loss in a Power Transformer

    This note obtains loss distribution for each component in drive condition and checks local overheating.

  7. [JAC184] Reactor Sound Pressure Analysis taking Magnetostriction into Account

    These notes will conduct an analysis of changed vibratory force and show a case study of confirming the impact magnetostriction has on vibration noise.

  8. [JAC183] Agitation Force Analysis of an Induction Furnace

    This analysis will evaluate the size of Lorentz force required to agitate and where this is generated.

  9. [JAC180] Analysis of SR Motor Dynamic Characteristics

    This example presents how to carry out an analysis with different switch timings to evaluate torque and current in SR motors.

  10. [JAC179] Analysis of SR Motor Static Characteristics

    This example presents an evaluation for each rotor position of the effect on flux linkage (shown as I-Psi characteristics below) when excitation current is changed.

  11. [JAC178] Analysis of SR Motor I-Psi Characteristics

    This example presents an evaluation of flux linkage, inductance and torque for each rotor position when the flowing current value is changed.

  12. [JAC177] Torque Characteristic Analysis of a Three Phase Induction Motor

    This Application Note explains how to obtain the torque characteristics in an induction motor when the current amplitude has been changed in a specific slip.

  13. [JAC173] Basic Characteristic Analysis of an IPM Motor

    This Application Note demonstrates an analysis in which an IPM motor's cogging torque, torque, magnetic flux density distribution, and iron loss in the stator core are obtained.

  14. [JAC172] High-Frequency Induction Heating Analysis of a Test Piece (Rotational Induction Hardening)

    This Application Note explains how to create a numerical analysis model when obtaining the optimum coil geometry, current conditions (power supply frequency, current value), and r…

  15. [JAC176] Drive Characteristic Analysis of a Three-Phase Induction Motor

    This Application Note explains how to confirm drive characteristics such as torque, loss, and efficiency in an induction motor when its rotation speed changes.

  16. [W-MO-23] Measurement of PM Motor Vibration/Noise and Analysis Modeling

    While miniaturization and efficiency optimization are always in demand in motor development, demand is also increasing for the reduction of vibration and noise in recent years. As…

Search Filter

  • All Categories