[JFT054] Output Types for the Spatial Modes of Electromagnetic Force Using FFT

This document describes the procedure to confirm the spatial modes of the electromagnetic force acting on a stator using a radar graph from electromagnetic force analysis results …

• Technical Themes: Multiphysics

[JFT113] Running Calculations by Grouping Multiple Jobs Using SSH

JMAG is capable of grouping multiple jobs and registering them to the job management system.

[JFT043] Frequency Filter Calculation on Distribution Amounts Obtained with Transient Response Analysis

This document describes a method for displaying filtered distribution amounts only in specific frequency components by using the frequency filter calculation function.

[JFT128] Evaluating Drive Cycle Time Using Efficiency Maps

This document describes the method for using obtained efficiency maps to confirm the efficiency history, operating points, cluster points, and total energy, etc., for drive cycle …

• Technical Themes: Efficiency map

[JFT141] JMAG-RT Model Data File Creation Function in JMAG-Designer

This document will show you how to export the efficiency map/loss map obtained in JMAG as a JMAG-RT model data file and to check the plot in JMAG RT-Viewer.

• Technical Themes: Efficiency map

[JFT070] Creating PM Motor Efficiency Maps Using JMAG-Designer (Accuracy Priority Mode)

This document describes how to create efficiency map studies (accuracy priority mode) using a JMAG-Designer efficiency map study (speed priority mode).

• Technical Themes: Design Exploration / Optimization, Efficiency map, and MBD

[JFT025] Creating a Graph Showing the Correlation between Time History Physical Quantities

In this document, the procedure for displaying the correlation between two physical quantities on a graph is presented.

[JFT037] Displaying Differences in Distributions

This document shows how to display the distribution difference contour plot using the result difference calculation function.

[JFT159] How to Create Motor Design Using Models & Scenarios

This enables you to create motor models, run analysis and evaluate the results in fewer steps.This document explains the procedure on how to create models using the templates and…

• Technical Themes: Design Exploration / Optimization and Efficiency map

[JFT003] Evaluation of Hysteresis Loops and Loss Density Distributions inside an Electromagnetic Steel Sheet

In this document, the procedure for evaluating iron loss distribution for the thickness direction of steel sheets is presented.

• Technical Themes: Material Modeling / Loss Analysis

[JFT040] Creating Specified Outputs Using Distribution Results

In this document, how to define an expression of an output and how to display its contour plot is described.

[JFT041] Simple Skew Analysis Using Results Data

In this document, how to use the skew graph function is described.

[JFT014] Physical Amount Calculation for Any Cross Section

This document shows how to define any cross section, using that defined cross section and settings to calculate physical amounts, and how to confirm results.

[JFT023] Frequency Component Analysis of Distributions Obtained by Transient Response Analysis

This document shows how to display output results ij vector form using the Fourier transform calculation function.

[JFT110] Evaluating the Effect of the Large Number of Holes Generated by Topology Optimization

This document describes how to efficiently analyze the presence or absence of an effect on hole response values when a large number of holes are generated as a result of topology …

[JFT095] Obtaining Distribution Data from a Results File

In this document, how to use APIs to obtain physical quantity data from a results file is presented.