IPM Motor
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC305] Loss Analysis of IPM Motor During Driving Cycle Considering Temperature Variation
In this example, we evaluate the time variation of losses and temperature during WLTC driving cycles when using an efficiency map with temperature dependency in an IPM motor.
-
[JAC302] Optimization of IPM Motor Geometry and Coil Turns
This case study optimizes IPM motor geometry and coil turns by using objective functions to maximize the average efficiency of several operating points and minimize the volume to …
-
[JAC205] Analyzing the Torque Characteristics of IPM Motors Using a Thermal Equivalent Circuit
Here, we confirm a situation where temperature increases due to eddy current of the iron loss and magnet, which causes demagnetization of the magnet and torque reduction.
-
[JAC303] Geometry Optimization of a Motor Considering Vibration at System-level
In this document, the dimensional optimization of a single motor is performed to minimize the vibration at the system level.
-
[JAC267] IPM Motor Topology Optimization Using the Density Method
Magnetic field and structural coupled analysis is run in this example. While accounting for rotor core strength, topology optimization that uses the density method is used to perf…
-
[JAC290] Design Exploration of IPM Motors, Including Evaluating Part Temperature, Stress, and the Presence of Electric Breakdown
In this example, the part temperature and stress are evaluated at the same time for the motor design plan, and a design plan that meets the requirements is explored.
-
[JAC296] Torque Characteristic Analysis of an IPM Motor Accounting for Temperature Distribution and Changes in Temperature
In this example, magnetic field and thermal coupled analysis is run, and changes in torque due to part temperatures and magnet demagnetization are checked.
-
[JAC295] Inverter Changeover Control for an Open-end Winding Motor
This case study runs a circuit simulation of an open-end winding motor drive system that switches from using a single inverter to dual inverters during operation in order to mitig…
-
[JAC222] Irreversible Thermal Demagnetization Analysis of Incompletely Magnetized Magnets
In this example, analysis is performed while varying the temperature of magnetized magnets, and then the influence on the torque waveform and magnetic flux density distribution is…
-
[JAC122] Inductance Analysis of an IPM Motor -d/q-axis Inductance Obtained by Actual Measurement-
This Application Note presents an analysis that obtains d/q-axis inductance in an IPM motor while assuming actual measurements in a stationary rotor.
-
[JAC292] Evaluating Energy Consumption During Drive Cycle Using Loss Maps with Temperature Dependency for IPM Motors
In this example, loss maps with temperature dependency for an IPM motor are used to compare and evaluate the energy consumption and efficiency during a WLTC drive cycle while usin…
-
[JAC286] IPM Motor Iron Loss Analysis Accounting for PWM -Evaluation with Different Modulation Methods-
In this example, the effects on iron loss when the modulation method for PWM control is changed are evaluated.
-
[JAC279] Thermal Analysis Accounting for Cooling of the IPM Motor
In this example, thermal equivalent circuit is used to run thermal analysis of a 3-phase IPM motor that accounts for cooling, and check the temperature change in the coil.
-
[JAC018] Thermal Analysis of a Motor
In this example, how to evaluate a motor's temperature distribution by creating a thermal analysis model that can investigate the loss analysis and temperature distribution in ord…
-
[JAC273] Creating IPM Motor Efficiency Maps Accounting for AC Loss
In this example, an IPM motor efficiency map that accounts for AC loss from a PWM is created, and a comparison with an efficiency map that does not account for AC loss is performe…
-
[JAC214] Monitoring the Radial Force Acting on the Teeth of IPM Motors Using Circuit Control Simulation
In this example, an IPM motor as a JMAG-RT model is captured in a control/circuit simulator, and radial forces acting on the teeth during motor driving is monitored while changing…
