DP
Transient Magnetic (2D/Axisymmetric)
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC211] IPM Motor Wire Joule Loss Analysis
In this example, evaluation of coil joule loss that includes eddy currents during motor rotation is introduced here.
-
[JFT123] Accounting for Residual Strain
This document explains the procedure for executing magnetic field analysis and iron loss analysis that account for residual strain.
-
[JAC103] Efficiency Analysis of a Permanent Magnet Synchronous Motor
In this example, how to obtain the efficiency with a sinusoidal wave voltage drive at a rotation speed of 1,800 r/min and voltage amplitude of 40 V.
-
[JFT126] Vectorizing Signals in a Control Circuit (MUX, DEMUX)
This document describes the methods for using a signal vectorization component (MUX) and vector disassembling component (DEMUX) in a control circuit.
-
[JFT129] Adding Efficiency Map (Speed Priority Mode) Response Values
This document describes how to use accuracy priority mode for operating point information obtained in speed priority mode.
-
[JFT128] Evaluating Drive Cycle Time Using Efficiency Maps
This document describes the method for using obtained efficiency maps to confirm the efficiency history, operating points, cluster points, and total energy, etc., for drive cycle …
-
[JFT136] Sending SSH Settings to Remote Machines
This document describes the method for sending SSH settings configured on local machines to remote machines for executing other case calculations.
-
[JFT125] Inheriting Operating Points Between Modes in Efficiency Map Studies
This document describes the method for using operating point information obtained with speed priority mode in accuracy priority mode.
-
[JFT131] Evaluating Degrees of Similarity for Geometry Using NGnet Weight
This document describes a method where after executing topology optimization using NGnet, degrees of similarity for geometry from NGnet weight are evaluated.
-
[JFT122] Executing Optimization Calculations Using Reduced Order Models
This document describes the method for executing simple analysis and optimization using a reduced order model.
-
[JFT133] System Loss Evaluations in System-Level Simulations
This document describes the method to output an efficiency map / loss map obtained with JMAG and using a circuit simulation to comprehend drive cycle system loss.
-
[JAC276] Six-Phase IPM Motor Harmonic Iron Loss Analysis
In this example, confirming the effects of carrier harmonics on the iron loss of a six-phase IPM motor are explained here.
-
[JAC265] Creating Synchronous Reluctance Motor Efficiency Maps
In this example, the efficiency map of a synchronous reluctance motor is created with loss ratios at each operating point also evaluated.
-
[JAC210] Torque Decoupling of In-out Magnet Coupling
This document, presents an analysis for finding holding torque and an analysis for transient response during torque decoupling.
-
[JAC264] Creating 6-Phase IPM Motor Efficiency Maps
In this example, the efficiency map of a 6-phase IPM motor is created with loss ratios at each operating point also evaluated.
-
[RTML-048] WFSM_02
Type: WFSM | Max Power: 2(kW) | Stator(Outside Diameter): 260(mm) | Height: 60(mm) | Voltage/Current: DC200(V)/20(A),DC100(V)/10(A) | Rotor/Mover: WF | Number of Phases: 6
