JMAG-Designer
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JFT145] How to Arrange Windings That Are in Parallel Circuits on Specified Layers
This document explains the procedure on how to set series-parallels of coils and switch the position in slots.
-
[JAC113] Power Transmission Analysis of a Wireless Power Transfer System with Opposing Cores
This Application Note presents how to obtain the power transmission efficiency when the feeder wire’s position is moved in both the horizontal and vertical directions from a refer…
-
[W-MO-12] Comparative Evaluation of Synchronous Impedance of a 2D Model and a 3D Model
This case study makes the differences clear between 2D and 3D models by comparing the synchronous impedances obtained from the analysis results of 2D and 3D models, and shows that…
-
[W-SE-101] Detailed Eddy Current Analysis of End Winding with Parallel Processing
To accurately obtaining the end-winding eddy current loss at high rotation speed, the influence of the magnetic field flux generated by the eddy current flow in every part of the …
-
[JAC264] Creating 6-Phase IPM Motor Efficiency Maps
In this example, the efficiency map of a 6-phase IPM motor is created with loss ratios at each operating point also evaluated.
-
[JAC210] Torque Decoupling of In-out Magnet Coupling
This document, presents an analysis for finding holding torque and an analysis for transient response during torque decoupling.
-
[JAC265] Creating Synchronous Reluctance Motor Efficiency Maps
In this example, the efficiency map of a synchronous reluctance motor is created with loss ratios at each operating point also evaluated.
-
[JAC276] Six-Phase IPM Motor Harmonic Iron Loss Analysis
In this example, confirming the effects of carrier harmonics on the iron loss of a six-phase IPM motor are explained here.
-
[JFT133] System Loss Evaluations in System-Level Simulations
This document describes the method to output an efficiency map / loss map obtained with JMAG and using a circuit simulation to comprehend drive cycle system loss.
-
[JFT131] Evaluating Degrees of Similarity for Geometry Using NGnet Weight
This document describes a method where after executing topology optimization using NGnet, degrees of similarity for geometry from NGnet weight are evaluated.
-
[JFT125] Inheriting Operating Points Between Modes in Efficiency Map Studies
This document describes the method for using operating point information obtained with speed priority mode in accuracy priority mode.
-
[JFT136] Sending SSH Settings to Remote Machines
This document describes the method for sending SSH settings configured on local machines to remote machines for executing other case calculations.
-
[JFT128] Evaluating Drive Cycle Time Using Efficiency Maps
This document describes the method for using obtained efficiency maps to confirm the efficiency history, operating points, cluster points, and total energy, etc., for drive cycle …
-
[JFT126] Vectorizing Signals in a Control Circuit (MUX, DEMUX)
This document describes the methods for using a signal vectorization component (MUX) and vector disassembling component (DEMUX) in a control circuit.
-
[JAC103] Efficiency Analysis of a Permanent Magnet Synchronous Motor
In this example, how to obtain the efficiency with a sinusoidal wave voltage drive at a rotation speed of 1,800 r/min and voltage amplitude of 40 V.
-
[JAC032] Analysis of a Transformer
In this example, the use of a magnetic field analysis to evaluate changes in the secondary voltage caused by load variations in a low frequency transformer.
