JMAG-Designer
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JFT142] Creating Shapes Using a Local Coordinate System
This document describes the method for using local coordinate systems to create shapes and changing the shapes parametrically.
-
[JFT135] Distributed Execution of Topology Optimization Calculation Using SSH
This document describes how to perform topology optimization calculations with the on/off method on a Linux remote machine via SSH.
-
[JAC228] Induction Motor Thermal Analysis
In this example, evaluating induction motor temperature distribution.
-
[JFT147] Creating a Lookup Table Using Parametric Analysis
This document explains how to run parametric analysis in JMAG-Designer and register it as a lookup table for MATLAB.
-
[JFT137] Current Restraints using Conditional Branches of Equation
This document explains how to restrain current value that is fed into the coils when geometry and electric resistance change.
-
[JFT144] Flux Linkage Calculations in a Specified Position
This document explains the procedure to set user-selected points in air regions and calculate flux linkage at these points.
-
[JFT141] JMAG-RT Model Data File Creation Function in JMAG-Designer
This document will show you how to export the efficiency map/loss map obtained in JMAG as a JMAG-RT model data file and to check the plot in JMAG RT-Viewer.
-
[JFT145] How to Arrange Windings That Are in Parallel Circuits on Specified Layers
This document explains the procedure on how to set series-parallels of coils and switch the position in slots.
-
[JAC113] Power Transmission Analysis of a Wireless Power Transfer System with Opposing Cores
This Application Note presents how to obtain the power transmission efficiency when the feeder wire’s position is moved in both the horizontal and vertical directions from a refer…
-
[W-MO-12] Comparative Evaluation of Synchronous Impedance of a 2D Model and a 3D Model
This case study makes the differences clear between 2D and 3D models by comparing the synchronous impedances obtained from the analysis results of 2D and 3D models, and shows that…
-
[W-SE-101] Detailed Eddy Current Analysis of End Winding with Parallel Processing
To accurately obtaining the end-winding eddy current loss at high rotation speed, the influence of the magnetic field flux generated by the eddy current flow in every part of the …
-
[JAC264] Creating 6-Phase IPM Motor Efficiency Maps
In this example, the efficiency map of a 6-phase IPM motor is created with loss ratios at each operating point also evaluated.
-
[JAC265] Creating Synchronous Reluctance Motor Efficiency Maps
In this example, the efficiency map of a synchronous reluctance motor is created with loss ratios at each operating point also evaluated.
-
[JAC276] Six-Phase IPM Motor Harmonic Iron Loss Analysis
In this example, confirming the effects of carrier harmonics on the iron loss of a six-phase IPM motor are explained here.
-
[JFT133] System Loss Evaluations in System-Level Simulations
This document describes the method to output an efficiency map / loss map obtained with JMAG and using a circuit simulation to comprehend drive cycle system loss.
-
[JFT131] Evaluating Degrees of Similarity for Geometry Using NGnet Weight
This document describes a method where after executing topology optimization using NGnet, degrees of similarity for geometry from NGnet weight are evaluated.
