Design Exploration / Optimization
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JFT111] Accounting for Arbitrary Motions
This document describes a method of accounting for arbitrary motions in the moving parts of electrical equipment.
-
[JAC258] Magnetic Shield Geometry Optimization
In this example, a case study in which the geometry of a magnetic shield is optimized using topology optimization that uses a sensitivity analysis (density method) is presented. D…
-
[JAC252] Geometry Optimization of a Solenoid Valve
In this example, an example where the geometry of a solenoid valve is optimized using a multi-objective optimization algorithm is presented.
-
[JAC261] SPM Motor Magnet Coercive Force Optimization For Obtaining Sinusoidal Magnetization
In this example, a magnet is segmented into blocks and coercive force is defined. The coercive force of each block is calculated so that the induced voltage waveform approaches a …
-
Electric Noise in Cars from Inverter Current to Noise
Mehdi Mehrgou, AVL List Gmbh.
-
Application of Deep Learning to Optimal Design
Hajime Igarashi, Hokkaido University
-
Optimization Design of IPMSM for Off-Highway Vehicle Using JMAG
Yuto Kimura, Yanmar. Co., Ltd.
-
Guided Optimization of Rotor Topologies in Electric Machines
Bernd Cebulski, IAV GmbH
-
FET Switching Control of PAM Inverter Circuit and Motor Characteristics Optimization of PWM Inverter Circuit
Manabu Kawaji, Aisin Seiki Co., Ltd.
-
Development of a Wireless Power Transfer System for Railway Vehicles Using JMAG
Keigo Ukita, Railway Technical Research Institute
-
[JFT100] Material Allotment per Element
In this document, how to set a different material for each element of a part and how to create multiple cases with different material specifications for the elements is presented.
-
[JAC236] Magnetic Circuit Optimization for Plastic Magnets in an Axial Magnetic Field
In this example, a use case is presented in which a magnetic circuit of a product-forming mold, in a magnetic field aligned with the mold’s main axis, is optimized, with the mold’…
-
[JFT098] Automatic Thread Allocation During Local Job Execution
In this document, how to optimally allocate threads to cores is presented.
-
[JFT096] Performing Parametric Analysis Using an Analysis Parameter View
In this document, how to perform parametric analysis using an analysis parameter view and how to check the results is presented.
-
[L-OP-109] Exploration of New Ideas Using Topology Optimization
The requirements for motor design are getting more advanced, satisfying torque ripple, line voltage limit, stress of core, as well as maximize the torque at low and high speeds. I…
-
[L-OP-107] Parameterize the Number of Poles and Slots
In the initial stage of motor design, combinations of various motor types, numbers of poles, and numbers of slots are considered to find a design that meets the requirements. When…
