Motor
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC131] Stray Capacitance Analysis of a Motor
This note presents the use of analysis to obtain the stray capacitance between an IPM motor’s coil and stator core, between its rotor core and stator core, and between the inner a…
-
[JAC091] Iron Loss Analysis of an IPM Motor Including the Effects of Press Fitting Stress
This Application Note presents modeling the press fitting of a core and frame with the Press Fit condition and then obtaining the iron loss density of an IPM motor with and withou…
-
[JAC112] Starting Thrust Force Analysis of a Linear Induction Motor
This Application Note presents how to obtain the starting thrust force for a linear inductance motor.
-
[JAC089] Stiffness Torque Analysis of a PM Stepper Motor
This Application Note describes how the stiffness torque at 0.5 A of current can be calculated for a PM stepper motor.
-
[JAC119] Torque Characteristic Analysis of a Three Phase Wound Rotor Induction Motor
This Application Note shows how to obtain the current density distribution and slip-torque curve.
-
[JAC094] Analysis of Detent Torque of a PM Stepper Motor
This Application Note describes how the detent torque can be calculated for a PM stepper motor.
-
[JAC080] Cogging Torque Analysis of an SPM Motor with Skewed Magnetization
This Application Note presents the use of a magnetic field analysis to obtain the flux density distribution, cogging torque, and induced voltage of an SPM motor that has skewed ma…
-
[JAC087] Iron Loss Analysis of an IPM Motor Including the Effect of Shrink Fitting
This document will compare the results of iron loss accounting for only the size of stress, and iron loss accounting for changes in magnetic flux density over time for each princi…
-
[JAC106] Iron Loss Analysis of a Brush Motor
This note presents how to obtain the iron loss in the stator core and rotor core of a brush motor.
-
[JAC159] Sensitivity Analysis of Dimensional Tolerance in an SPM Motor
This Application Note presents how to assume a dimensional tolerance of ±0.4 mm for a chamfer, and find out whether changing dimensions within the tolerance range has an effect on…
-
[JAC129] Analysis of a PM Stepper Motor Accounting for Magnetization
In this analysis, a magnetization device model is created and a magnet is magnetized. The magnetization distribution and surface magnetic flux density of the magnetized magnet, an…
-
[JAC058] Efficiency Analysis of an IPM Motor
This Application Note presents the use of magnetic field analysis to obtain the efficiency of an IPM motor in each current phase with a rotation speed of 1800 rpm and the current …
-
[JAC054] Analysis of the Cogging Force of a Moving Coil Linear Motor
This Analysis Note explains how to obtain the magnetic flux density distribution and cogging in a moving coil linear motor with skew applied to its magnets.
-
[JAC056] Torque Characteristics Analysis of a Self Starting Type Permanent Magnet Motor
This Application Note shows how to obtain the current density distribution and slip versus torque curve.
-
[JAC055] Integrated Magnetization Analysis of an IPM Motor
This Application Note explains how to determine the changes that occur in a magnetizing field if the making current is changed during magnetization, as well as how to obtain the i…
-
[JAC068] Speed Versus Torque Characteristic Analysis of a Three-Phase Induction Motor
This Application Note explains an analysis that confirms the Speed-Torque curve and current density distribution of an induction motor.
