DP
Transient Magnetic (2D/Axisymmetric)
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JFT144] Flux Linkage Calculations in a Specified Position
This document explains the procedure to set user-selected points in air regions and calculate flux linkage at these points.
-
[JFT141] JMAG-RT Model Data File Creation Function in JMAG-Designer
This document will show you how to export the efficiency map/loss map obtained in JMAG as a JMAG-RT model data file and to check the plot in JMAG RT-Viewer.
-
[JFT145] How to Arrange Windings That Are in Parallel Circuits on Specified Layers
This document explains the procedure on how to set series-parallels of coils and switch the position in slots.
-
[JAC264] Creating 6-Phase IPM Motor Efficiency Maps
In this example, the efficiency map of a 6-phase IPM motor is created with loss ratios at each operating point also evaluated.
-
[JAC210] Torque Decoupling of In-out Magnet Coupling
This document, presents an analysis for finding holding torque and an analysis for transient response during torque decoupling.
-
[JAC265] Creating Synchronous Reluctance Motor Efficiency Maps
In this example, the efficiency map of a synchronous reluctance motor is created with loss ratios at each operating point also evaluated.
-
[JAC276] Six-Phase IPM Motor Harmonic Iron Loss Analysis
In this example, confirming the effects of carrier harmonics on the iron loss of a six-phase IPM motor are explained here.
-
[JFT133] System Loss Evaluations in System-Level Simulations
This document describes the method to output an efficiency map / loss map obtained with JMAG and using a circuit simulation to comprehend drive cycle system loss.
-
[JFT131] Evaluating Degrees of Similarity for Geometry Using NGnet Weight
This document describes a method where after executing topology optimization using NGnet, degrees of similarity for geometry from NGnet weight are evaluated.
-
[JFT125] Inheriting Operating Points Between Modes in Efficiency Map Studies
This document describes the method for using operating point information obtained with speed priority mode in accuracy priority mode.
-
[JFT136] Sending SSH Settings to Remote Machines
This document describes the method for sending SSH settings configured on local machines to remote machines for executing other case calculations.
-
[JFT128] Evaluating Drive Cycle Time Using Efficiency Maps
This document describes the method for using obtained efficiency maps to confirm the efficiency history, operating points, cluster points, and total energy, etc., for drive cycle …
-
[JFT126] Vectorizing Signals in a Control Circuit (MUX, DEMUX)
This document describes the methods for using a signal vectorization component (MUX) and vector disassembling component (DEMUX) in a control circuit.
-
[JAC103] Efficiency Analysis of a Permanent Magnet Synchronous Motor
In this example, how to obtain the efficiency with a sinusoidal wave voltage drive at a rotation speed of 1,800 r/min and voltage amplitude of 40 V.
-
[JFT123] Accounting for Residual Strain
This document explains the procedure for executing magnetic field analysis and iron loss analysis that account for residual strain.
-
[JAC211] IPM Motor Wire Joule Loss Analysis
In this example, evaluation of coil joule loss that includes eddy currents during motor rotation is introduced here.
