Magnetic Field
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC064] Thrust Force Analysis of a Coreless Linear Motor
In this example, explains how to obtain the thrust variations in a coreless linear motor when it is driven with a three-phase alternating current.
-
[JAC007] Analysis of a Spindle Motor
In this example, how the Speed-Torque curve, the Torque-Current curve and the magnetic flux density distribution of a spindle motor can be obtained.
-
[L-MU-91] NVH analysis of EV drivelines with JMAG and Romax Nexus
NVH is the one of most critical issues in the drivelines development of EV/ HEV. There are several points to be considered for the NVH analysis of the driveline. To evaluate the N…
-
[JAC208] High Frequency Induction Hardening Analysis Accounting for Deformation (Abaqus Link)
This document introduces evaluates how heating ranges change depending on the deformation amount at high temperatures and deformation during heating, with heat generation analysis…
-
[JAC244] Magnetic Field Strength Analysis at a Sensor Position
In this example, with the analysis target being a motor and the detection sensor being a TMR sensor, an example where a detection signal waveform is obtained that is based on magn…
-
[JAC218] High-Frequency Induction Hardening Analysis Accounting for Deformation
In this example, using the JMAG magnetic field - thermal stress coupled analysis function, analysis is performed evaluating gear deformation from induction heat hardening.
-
[JAC255] Evaluating the N-T Curve of an IPM motor Using 3D Correction
In this example, obtains N-T curves using the correction function.
-
[L-OP-61] Smooth and robust optimization process in JMAG
The optimization is indispensable in machines design. Especially the optimization must consider not only the magnetic design issues but also the mechanical and the thermal design …
-
[W-SE-75] Iterative Calculations and Convergence Characteristics
In this report, we will explain the convergence criteria of a local quantity and the improvement of the determination of convergence of ICCG. And then, we describe that these idea…
-
[W-SE-72] Reduction of Time Steps by Using Time Periodic Explicit Error Correction Method
In electrical equipment design, Computer Aided Engineering (CAE) software is used to make the best possible products within allowable timelines.
-
[W-SE-74] Electromagnetic Force Calculations Using the Adaptive Function
In this report, we clarify the causes of measurement errors for electromagnetic force as well as show that adaptive analysis can be the way to solve this issue. As a calculation m…
-
[W-MO-24] Copper Loss Analysis of a Rotating Machine Using the Zooming Method
In this paper, this method is applied to a copper loss characteristics analysis of wires in a 2D rotating machine as well as a loss analysis of litz wires in a 3D rotating machine…
-
[W-TR-15] Loss Evaluation of a Transformer Shield Based on the Homogenization Method
In this paper, each electromagnetic steel sheet of the shield is not modeled; by applying the homogenization method which replaces magnetically and electrically equivalent materia…
-
[W-MA-47] Toward Practical Application of Iron Loss Analysis Taking Stress into Account
Increasing the accuracy of an iron loss analysis for a magnetic field analysis poses challenges. With conventional iron loss calculation methods, the iron loss characteristics of …
-
[W-MA-50] Effectiveness and Limits of 2D Analysis from Loss Analysis
In electromagnetic field analysis, 2D analysis (FEM) that include iron loss evaluations are widely used as a way to find a balance between finely detailed analysis and convenient …
-
[W-MO-13] Evaluation of a 2D Brush Motor Analysis Accounting for 3D Geometry
In this applied case, the structure of a 2D analysis model accounting for 3D geometry is evaluated through the comparison with a 3D analysis model. The modeling validity is proved…