Motor
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
Improvement of Calculation Model on Induction Motors
Daisuke Sato, Nagaoka Motor Development Co., Ltd.
-
Torsional Vibration Analysis of an Electric-Drive Powertrain Via System Simulations with Simcenter Amesim and JMAG-RT
Florent Pasteur / Damien Aguilera / Gabriel Autefage, Siemens Digital Industry Software
-
[JAC231] Vector Control Simulation of a Synchronous Reluctance Motor
In this example, circuit simulation is carried out simulating the control of current and speed by loading a JMAG-RT model for a SynRM into a control/circuit simulator. In addition…
-
[JAC230] 6-Phase SPM Motor Inverter Fault Simulation
In this example, a JMAG-RT model of a 6-phase SPM is loaded into a control/circuit simulator, and circuit simulation for an inverter failure is carried out.
-
[JAC274] SPM Motor Thermal Demagnetization Analysis Using Bonded NdFeB Magnets
In this example, an SPM motor thermal demagnetization analysis is performed using bonded NdFeB magnets. Both the influence on torque waveforms when changing rotor magnet temperatu…
-
[JAC272] Thrust Analysis of Linear Actuator with a Curved Section
In this example, the thrust characteristics of a linear actuator with a curved section are obtained via analysis, and thrust at the transition from a linear motion to a curved mot…
-
[JAC271] Axial Gap Type Motor AC Copper Loss Analysis
In this example, the AC copper loss of an axial gap type motor using square wire is evaluated.
-
[JAC257] IPM Motor Topology Optimization
In this example, rotor core maximum stress and radial direction maximum displacement in the radial direction are set to certain values or less, and rotor geometry is designed that…
-
[JAC225] Induced Voltage Analysis on Memory Motors Using Variable Magnets
In this example, the change in motor characteristics are checked as the memory motor variable magnet magnetization is changed using the three-phase coil current. One example of mo…
-
[JAC259] Automatically Searching for Current Phase that Obtains Maximum Torque and Evaluating Torque Characteristics
In this example, the current phase that maximizes the torque is searched for each of three rotor geometries. The motor average currents and torque ripples are evaluated using the …
-
[L-HU-08] Complex 3D Models to FEA Models Within Short Timeframes
Amounts of processing required will increase proportionately to the number of parts. By applying parallel processing, mesher processing speed increases, and mesh generation time i…
-
[JAC263] Stress Analysis of an IPM Motor Accounting for Contact Between the Magnets and Rotor Core
This case study compares the von Mises stress obtained by two analysis cases to evaluate the influence the contact between the magnets and rotor core of an IPM motor have on the s…
-
[JAC261] SPM Motor Magnet Coercive Force Optimization For Obtaining Sinusoidal Magnetization
In this example, a magnet is segmented into blocks and coercive force is defined. The coercive force of each block is calculated so that the induced voltage waveform approaches a …
-
[L-HU-01] High Performance Parallel Solver Analyzing Complex Phenomena in Rotating Machines As Is
JMAG's high parallel solver exhibits high performance and has answers to a wide range of problems for in practice.
-
[JAC022] Analysis of the Eddy Current in the Magnet of an IPM Motor
This Application Note presents the use of a magnetic field analysis in a state of operation to obtain variations in magnet eddy current losses according to the number of divisions…
-
Initiatives in Toyota Vehicle Electrification and Developing Electrified Vehicles: Anticipating JMAG’s Support in the Development of Electrified Vehicles
Hideto Hanada, TOYOTA MOTOR CORPORATION
