Axial Gap Type Motor
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC277] Vibration Analysis of Axial Gap-Type Motor
In this example, phenomena confirmed in axial gap-type motors that occur at maximum sound pressure level, from an electromagnetic excitation force and eigen mode perspective.
-
[JAC275] IPM Motor Iron Loss Analysis Accounting for the Effect of Residual Strain
In this document, an analysis of an IPM motor accounting for the residual strain that occurs as a result of punching processes, and evaluates the effect on torque, magnetic flux d…
-
[JAC230] 6-Phase SPM Motor Inverter Fault Simulation
In this example, a JMAG-RT model of a 6-phase SPM is loaded into a control/circuit simulator, and circuit simulation for an inverter failure is carried out.
-
[JAC274] SPM Motor Thermal Demagnetization Analysis Using Bonded NdFeB Magnets
In this example, an SPM motor thermal demagnetization analysis is performed using bonded NdFeB magnets. Both the influence on torque waveforms when changing rotor magnet temperatu…
-
[JAC271] Axial Gap Type Motor AC Copper Loss Analysis
In this example, the AC copper loss of an axial gap type motor using square wire is evaluated.
-
[JAC257] Topology Optimization of an IPM Motor
This case study runs a topology optimization to minimize torque ripple and maximize average torque with the maximum stress on the rotor core and maximum radial displacement below …
-
[JAC225] Induced Voltage Analysis on Memory Motors Using Variable Magnets
In this example, the change in motor characteristics are checked as the memory motor variable magnet magnetization is changed using the three-phase coil current. One example of mo…
-
[JAC263] Stress Analysis of an IPM Motor Accounting for Contact Between the Magnets and Rotor Core
This case study compares the von Mises stress obtained by two analysis cases to evaluate the influence the contact between the magnets and rotor core of an IPM motor have on the s…
-
[JAC261] SPM Motor Magnet Coercive Force Optimization For Obtaining Sinusoidal Magnetization
In this example, a magnet is segmented into blocks and coercive force is defined. The coercive force of each block is calculated so that the induced voltage waveform approaches a …
-
[JAC262] IPM Motor Thermal Demagnetization Analysis Accounting for Dy-Diffusion Magnet Incomplete Magnetization
In this example, the thermal demagnetization resistance of a motor is analyzed using Dy-diffusion magnets with a coercive force distribution under incomplete magnetization.
-
[JAC200] Iron Loss Analysis of IPM Motor using Hysteresis Model
In this example, a hysteresis model accounting for minor loops of the direct current bias magnetism and the lamination analysis function accounting for eddy current distribution i…
-
[JAC259] Automatically Searching for Current Phase that Obtains Maximum Torque and Evaluating Torque Characteristics
In this example, the current phase that maximizes the torque is searched for each of three rotor geometries. The motor average currents and torque ripples are evaluated using the …
-
[JAC030] Magnetization Field Evaluation of an SPM motor
In this example, carry out SPM motor's magnetization to obtain the magnetization field and magnet's surface magnetic flux density.
-
[JAC255] Evaluating the N-T Curve of an IPM motor Using 3D Correction
In this example, obtains N-T curves using the correction function.
-
[JAC142] Press Fit Analysis of a Divided Core
This Application Note presents how to use the Press Fit condition to model an analysis of the stress from fitting a core to a frame, and then obtain the iron loss density of an IP…
-
[JAC195] Torque characteristics analysis of three-phase induction motors using 3D correction function
This document introduces introduces a case study which obtains inductance correction values, and then obtains N-T characteristics (revolution speed-torque characteristics) using t…
