JMAG-Designer
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JFT081] Creating an Induction Motor Efficiency Map Using JMAG-Designer (Speed Priority Mode)
In this document, how to create an efficiency map of an induction motor using an efficiency map study (speed priority mode) in JMAG-Designer is presented.
-
[JFT074] High Accuracy Electromagnetic Force Calculation with the Correction Method and Adaptive Mesh
This document describes methods for calculating electromagnetic force working a coil and magnet at a high accuracy.
-
[JFT078] Stopping an Analysis Automatically After Reaching Steady-State
In this document, how to automatically stop analysis after steady-state is reached is presented.
-
[JFT068] Specifying Three-Phase Synchronous Motor dq Axis Current
This document explains how to specify a dq axis current and drive a motor.
-
[JFT057] How to Run Topology Optimization
This document describes how to run topology optimization using JMAG.
-
[JFT080] Direct Coupling between MATLAB/Simulink and JMAG
In this document, direct coupling between MATLAB/Simulink and JMAG is presented.
-
[JAC244] Magnetic Field Strength Analysis at a Sensor Position
In this example, with the analysis target being a motor and the detection sensor being a TMR sensor, an example where a detection signal waveform is obtained that is based on magn…
-
[JAC218] High-Frequency Induction Hardening Analysis Accounting for Deformation
In this example, using the JMAG magnetic field - thermal stress coupled analysis function, analysis is performed evaluating gear deformation from induction heat hardening.
-
[JAC255] Evaluating the N-T Curve of an IPM motor Using 3D Correction
In this example, obtains N-T curves using the correction function.
-
[L-OP-61] Smooth and robust optimization process in JMAG
The optimization is indispensable in machines design. Especially the optimization must consider not only the magnetic design issues but also the mechanical and the thermal design …
-
[JFT076] Methods for Running Geometry Optimization Using Multiple Studies
This document describes how to run geometry optimization using multiple studies.
-
[L-OP-03] Multi-Objective Optimization with JMAG
It is even possible to analyse the relationship between design variables and response values in a correlation graph by visualizing the design space from optimization calculation r…
-
[W-SE-75] Iterative Calculations and Convergence Characteristics
In this report, we will explain the convergence criteria of a local quantity and the improvement of the determination of convergence of ICCG. And then, we describe that these idea…
-
[W-SE-72] Reduction of Time Steps by Using Time Periodic Explicit Error Correction Method
In electrical equipment design, Computer Aided Engineering (CAE) software is used to make the best possible products within allowable timelines.
-
[W-SE-74] Electromagnetic Force Calculations Using the Adaptive Function
In this report, we clarify the causes of measurement errors for electromagnetic force as well as show that adaptive analysis can be the way to solve this issue. As a calculation m…
-
[W-MO-24] Copper Loss Analysis of a Rotating Machine Using the Zooming Method
In this paper, this method is applied to a copper loss characteristics analysis of wires in a 2D rotating machine as well as a loss analysis of litz wires in a 3D rotating machine…
