Steady/Transient Thermal (3D)
228 – Induction Motor Thermal Analysis
In this example, evaluating induction motor temperature distribution.
18 – Thermal Analysis of a Motor
This Application Note explains how to evaluate a motor’s temperature distribution by creating a thermal analysis model that can investigate the loss analysis and temperature distr…
218 – High-Frequency Induction Hardening Analysis Accounting for Deformation
In this example, using the JMAG magnetic field - thermal stress coupled analysis function, analysis is performed evaluating gear deformation from induction heat hardening.
250 – Dielectric Heating Analysis of a High-Frequency Preheater with Roller Electrodes
In this example, a use case is presented where the influence of the pitch of roller electrodes on the temperature distribution of a material (tablets) is evaluated.
220 – Analysis of the High-Frequency Induction Hardening and Cooling of a Gear
In this example, deals with induction heating and cooling analysis. An example is presented where the cooling rate for a gear differs depending on the cooling conditions.
249 – Dielectric Heating Analysis of a High-Frequency Preheater with Parallel Plate Electrodes
In this example, a use case evaluating the influence on the temperature distribution of materials (tablets) with and without auxiliary electrodes is presented.
233 – Induction Heating Coil Optimization
In this example, an example of using an optimization function to design a coil to use for induction hardening a gear is presented.
198 – Bus Bar Thermal Stress Analysis
Here, temperature distributions for bus bars are obtained when the power supply frequency is changed.
186 – Gear Induction Hardening Analysis Using Two Frequencies
In this material, the validity of coil geometry used for quenching is evaluated by heating the gear top and bottom at high and low frequencies, respectively, to confirm uniform te…
172 – High-Frequency Induction Heating Analysis of a Test Piece (Rotational Induction Hardening)
This Application Note explains how to create a numerical analysis model when obtaining the optimum coil geometry, current conditions (power supply frequency, current value), and r…
146 – Analysis of Stray Loss in a Transformer
This Application Note explains how to obtain losses in a transformer tank and use them to evaluate the temperature distribution in each part.
133 – Thermal Analysis of a Three-phase Transformer
This Application Note presents an example of how to confirm a temperature distribution using the iron and copper losses of a three-phase transformer as heat sources.
130 – Thermal Conductivity Analysis of Basic Geometry
In this Application Note, the analysis accuracy is investigated by comparing the temperatures obtained through analysis in each part with theoretical values.
127 – Resistance Heating Analysis of Steel
This Application Note presents how to obtain the temperature distribution, temperature variations, and heat flux distribution in a body heated by ohmic heating.
123 – Thermal Analysis of a Choke Coil
This Application Note shows the use of a thermal analysis to obtain the temperature distribution using the iron losses and copper losses in the choke coil as the heat source.
44 – Resistance Heating Analysis of a Steel Sheet
This Application Note presents how to obtain the calculate current density distribution, Joule loss distribution and temperature distribution of steel sheet.