[JFT167] Adding Arbitrary Circuits to JMAG Model Equivalent Circuits

This document explains how to add arbitrary circuits when running JMAG-RT models with MATLAB/Simulink.

• Technical Themes: MBD

[JFT047] Performing Harmonic Loss Calculations with Current Control in JMAG-Designer

In this document, how to calculate the harmonic loss of a current controlled (PWM controlled) motor is described.

• Technical Themes: Material Modeling / Loss Analysis

[JFT134] Inheritance Between Current Waveform Studies

This document describes the method for setting a current waveform obtained from a 2D analysis to a 3D analysis automatically by using a post calculation script.

[JFT069] Performing Harmonic Loss Calculations Accounting for Current Control with JMAG-Designer and JMAG-RT

In this document, how to calculate the harmonic loss of a current controlled (PWM controlled) PM motor at high speed using a JMAG-RT model is presented.

• Technical Themes: Material Modeling / Loss Analysis and MBD

[JFT048] Brush / Commutator Component

In this document, how to use the Brush / Commutator component is described.

[JFT071] Creating User-Defined Calculation Components

This document describes methods for creating user-defined calculation components.

• Technical Themes: MBD

[JFT158] Several Circuit Conversion Sets

This document explains the procedure on how to set the conversion of multiple circuits in a cage type induction motor model.

[JFT160] How to Run Parametric Analysis With Changes Made to the Number of Model Slots and Poles for Motor Thermal Analysis Accounting for Cooling

This example describes how to run parametric analysis with changes made to the number of slots and the number of poles for a motor model that uses a thermal equivalent circuit.

[JFT143] How to Run Control Simulations Using Only JMAG-RT and a Circuit

This document describes the method for creating an integration study to run a control simulation in JMAG.

[JFT149] How to Create JMAG-RT Model with JMAG Designer and Run Consecutive Control Simulation

This document explains the procedure on how to create a JMAG-RT model in JMAG-Designer and how to use the created model to run consecutive control simulation.

• Technical Themes: Efficiency map

[JFT154] Automatic Generation of Motor Thermal Analysis Model of Rotating Machine that Accounts for Cooling

This document shows how to run scripts from a JMAG project file with any model to create a thermal analysis model with batch settings of circuit components and each thermal condit…

[JFT150] Running Calculations of Multiple Studies Connected on Circuits

This documents explains the procedures on how to run analysis of multiple FEM analysis connected on circuits in JMAG-Designer.

[JFT147] Creating a Lookup Table Using Parametric Analysis

This document explains how to run parametric analysis in JMAG-Designer and register it as a lookup table for MATLAB.

[JFT133] System Loss Evaluations in System-Level Simulations

This document describes the method to output an efficiency map / loss map obtained with JMAG and using a circuit simulation to comprehend drive cycle system loss.

• Technical Themes: Efficiency map

[JFT126] Vectorizing Signals in a Control Circuit (MUX, DEMUX)

This document describes the methods for using a signal vectorization component (MUX) and vector disassembling component (DEMUX) in a control circuit.

[JFT068] Specifying Three-Phase Synchronous Motor dq Axis Current

This document explains how to specify a dq axis current and drive a motor.