RT
Behavior Model Generation for Use in a Circuit/Control Simulator
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC299] Inverter Changeover Control for an Open-end Winding Motor (Wound-Field Synchronous Motor)
This case study runs a circuit simulation of an open-end winding motor drive system that switches from using a single inverter to dual inverters during operation in order to mitig…
-
H3X Integrated Motor Drives: Delivering World-Class Power Density for Maximum Vehicle Range
Max Liben, H3X Technologies
-
Applied Cases of EV Motor Controller Tuning by MILS using JMAG-RT
Nobuo Morimura, SUBARU CORPORATION
-
Investigation of Error Factors between Measurement and Analysis Results of Torque in a Permanent Magnet Synchronous Motor under High Speed Rotation
Masatsugu Takemoto, Okayama University
-
Model-Based Calibration Enables Optimal Torque Control of Synchronous Motors in a Short Time
Atsushi Katagiri, MathWorks Japan
-
SIMBA, Reinventing Motor Drive Simulation
Ryoko Imamura, Powersys
-
[JAC216] Simulation of a Claw-Pole Type Alternator Using a Control Simulator and JMAG-RT
In this example, the output voltage and field current of a claw-pole type alternator is checked when the rotor speed is changed.
-
[JAC214] Monitoring the Radial Force Acting on the Teeth of IPM Motors Using Circuit Control Simulation
In this example, an IPM motor as a JMAG-RT model is captured in a control/circuit simulator, and radial forces acting on the teeth during motor driving is monitored while changing…
-
[JFT173] Workflow and Key Points in Efficiency Map Analysis
It is intended for intermediate-level users who are able to use technical references to improve accuracy and efficiency of their analysis. Therefore, basic information and detaile…
-
[JAC098] Response Analysis of a Solenoid Valve Using a Control Simulator and the JMAG-RT
This note presents how JMAG-RT can be used to calculate attraction forces and coil inductance that varies with harmonic and current. The result is the JMAG-RT model used as a refe…
-
[JFT011] Tooth Electromagnetic Force Monitoring During Control Simulation
This document describes the preparation involved for outputting tooth electromagnetic force when creating a JMAG-RT model, MATLAB/Simulink settings, and the displaying of the obta…
-
[JFT176] Workflow and Key Points for Creating a JMAG-RT Model
OverviewThis document covers the general flow of using JMAG to create a JMAG-RT model and provides the key points for each step and useful functions.It is intended for intermediat…
-
[JAC037] Vector Control Analysis of an IPM Motor Using Control Simulator and the JMAG-RT
The purpose of this Application Note is to demonstrate how to import a JMAG-RT model to a control/circuit simulator after using the JMAG-RT to obtain the inductance spatial harmon…
-
[JAC134] Speed Control Analysis of a Permanent Magnet Linear Motor Using the Control Simulator and the JMAG-RT
This Application Note presents how to use JMAG-RT to obtain the spatial harmonics and current dependency of the thrust and coil inductance, and import them to a circuit/control si…
-
[JAC291] Control Simulation of Switching Number of Poles in a 6-Phase Induction Machine
In this document, the behavior of a 6-phase induction motor during the switching of the number of poles is evaluated by simulation.
-
[JAC215] Simulation of an IPM Motor with a Delta Connection Using a Control Simulator and JMAG-RT
In this example, a JMAG-RT model is incorporated into a control/circuit simulator to monitor the circulating current when an IPM motor is being driven.
