JMAG-Designer
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC259] Automatically Searching for Current Phase that Obtains Maximum Torque and Evaluating Torque Characteristics
In this example, the current phase that maximizes the torque is searched for each of three rotor geometries. The motor average currents and torque ripples are evaluated using the …
-
[JFT054] Output Types for the Spatial Modes of Electromagnetic Force Using FFT
This document describes the procedure to confirm the spatial modes of the electromagnetic force acting on a stator using a radar graph from electromagnetic force analysis results …
-
[JFT106] Multistage Analysis Using a Vector Potential Boundary Condition
In this document, how to perform multistage analysis using a vector potential boundary condition is presented.
-
[JAC258] Magnetic Shield Geometry Optimization
In this example, a case study in which the geometry of a magnetic shield is optimized using topology optimization that uses a sensitivity analysis (density method) is presented. D…
-
[L-HU-08] Complex 3D Models to FEA Models Within Short Timeframes
Amounts of processing required will increase proportionately to the number of parts. By applying parallel processing, mesher processing speed increases, and mesh generation time i…
-
[JAC252] Geometry Optimization of a Solenoid Valve
In this example, an example where the geometry of a solenoid valve is optimized using a multi-objective optimization algorithm is presented.
-
[JAC263] Stress Analysis of an IPM Motor Accounting for Contact Between the Magnets and Rotor Core
This case study compares the von Mises stress obtained by two analysis cases to evaluate the influence the contact between the magnets and rotor core of an IPM motor have on the s…
-
[L-MA-04] New & Improved Iron Loss Analysis Function
When performing iron loss analysis, it is necessary to select optimal methods accounting for the likes of analysis targets, objectives, accuracy, types of usable data, and more.
-
[JAC261] SPM Motor Magnet Coercive Force Optimization For Obtaining Sinusoidal Magnetization
In this example, a magnet is segmented into blocks and coercive force is defined. The coercive force of each block is calculated so that the induced voltage waveform approaches a …
-
[W-MO-17] Alternator Analysis Using Tetrahedral/Pentahedral Mixed Mesh
This paper looks at tetrahedral/pentahedral mixed mesh and aims to generate effective mesh to reduce calculation time. We compared calculation times and accuracy when analysis is …
-
[L-HU-01] High Performance Parallel Solver Analyzing Complex Phenomena in Rotating Machines As Is
JMAG's high parallel solver exhibits high performance and has answers to a wide range of problems for in practice.
-
[JAC022] Analysis of the Eddy Current in the Magnet of an IPM Motor
This Application Note presents the use of a magnetic field analysis in a state of operation to obtain variations in magnet eddy current losses according to the number of divisions…
-
Initiatives in Toyota Vehicle Electrification and Developing Electrified Vehicles: Anticipating JMAG’s Support in the Development of Electrified Vehicles
Hideto Hanada, TOYOTA MOTOR CORPORATION
-
Case Study of Developing an IPM Motor Drive System with Model-Based Development (MBD) – Using JMAG-RT and HILS –
Daisuke Mitsuoka, Shimadzu Corporation
-
Comprehensive System to Component xEV Simulation Using Gamma Technologies and JMAG
Joe Wimmer, Gamma Technologies, LLC
-
Fuel Consumption Simulations for Vehicles Equipped with HUB Bearings with Motor Generator (eHUB)
Mitsuo Kawamura, NTN Corporation
