Optimization
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC307] Topology Optimization of SPM Motor Using the Magnet Orientation Direction as a Design Variable
This case study runs an optimization to simultaneously explore the magnet topology and orientation directions through design variables to obtain at least the same torque as a Halb…
-
[JAC302] Optimization of IPM Motor Geometry and Coil Turns
This case study optimizes IPM motor geometry and coil turns by using objective functions to maximize the average efficiency of several operating points and minimize the volume to …
-
[JAC293] Axial Gap Motor Geometry Optimization Using Surrogate Models
In this example, the dimensions of an axial gap motor are optimized by using surrogate models, then the Pareto curves and the effect of reduction in calculation times when using s…
-
[JAC303] Geometry Optimization of a Motor Considering Vibration at System-level
In this document, the dimensional optimization of a single motor is performed to minimize the vibration at the system level.
-
[JAC267] IPM Motor Topology Optimization Using the Density Method
Magnetic field and structural coupled analysis is run in this example. While accounting for rotor core strength, topology optimization that uses the density method is used to perf…
-
[JAC288] Synchronous Reluctance Motor Topology Optimization
In this example, topology optimization is used to minimize the torque ripple and maximize the average torque when exploring the rotor geometry.
-
[JAC280] Topology Optimization of Induction Heating Coil
In this example, magnetic field and thermal coupled analysis is run, and using topology optimization, searches are performed for a heating coil that maximizes the power factor and…
-
[JAC190] Arrangement Optimization of Wireless Power Transfer System
This document introduces the procedure in obtaining the optimum solution for geometries of transmission coils (angle that defines position) for simple magnetic resonance wireless …
-
[JAC223] Multi-Objective Optimization of an IPM Motor Accounting for Stress at High-Speed Rotation
In this example, the optimum current phase that achieves high torque per each geometry is obtained, and the torque characteristics (1,000 r/min) and stress due to centrifugal forc…
-
[JAC268] SPM Motor Teeth Geometry Topology Optimization
In this example, the on / off method is used to search for stator teeth geometry that maximizes average torque and minimizes torque ripple with the entire areas of stator teeth ti…
-
[JAC233] Induction Heating Coil Optimization
In this example, an example of using an optimization function to design a coil to use for induction hardening a gear is presented.
-
[JAC257] IPM Motor Topology Optimization
In this example, rotor core maximum stress and radial direction maximum displacement in the radial direction are set to certain values or less, and rotor geometry is designed that…
-
[JAC258] Magnetic Shield Geometry Optimization
In this example, a case study in which the geometry of a magnetic shield is optimized using topology optimization that uses a sensitivity analysis (density method) is presented. D…
-
[JAC252] Geometry Optimization of a Solenoid Valve
In this example, an example where the geometry of a solenoid valve is optimized using a multi-objective optimization algorithm is presented.
-
[JAC261] SPM Motor Magnet Coercive Force Optimization For Obtaining Sinusoidal Magnetization
In this example, a magnet is segmented into blocks and coercive force is defined. The coercive force of each block is calculated so that the induced voltage waveform approaches a …
-
[JAC236] Magnetic Circuit Optimization for Plastic Magnets in an Axial Magnetic Field
In this example, a use case is presented in which a magnetic circuit of a product-forming mold, in a magnetic field aligned with the mold’s main axis, is optimized, with the mold’…
