Time Harmonic Magnetic (2D/3D)

Sort condition
Newest first
Oldest first
  1. 233 – Induction Heating Coil Optimization

    In this example, an example of using an optimization function to design a coil to use for induction hardening a gear is presented.

  2. 254 – Vibration Analysis of a Large Oil-Filled Transformer

    In this example, evaluating vibration caused by electromagnetic excitation in a large transformer. Since large transformers are oil-cooled, in this example the oil, which is the f…

  3. 208 – High Frequency Induction Hardening Analysis Accounting for Deformation (Abaqus Link)

    This document introduces evaluates how heating ranges change depending on the deformation amount at high temperatures and deformation during heating, with heat generation analysis…

  4. 218 – High-Frequency Induction Hardening Analysis Accounting for Deformation

    In this example, using the JMAG magnetic field - thermal stress coupled analysis function, analysis is performed evaluating gear deformation from induction heat hardening.

  5. 220 – Analysis of the High-Frequency Induction Hardening and Cooling of a Gear

    In this example, deals with induction heating and cooling analysis. An example is presented where the cooling rate for a gear differs depending on the cooling conditions.

  6. 224 – Wireless Power Transfer Device Stray Loss Analysis

    In this example, an example is presented investigating by using electromagnetic field analysis whether stray loss can be suppressed using an aluminum shield.

  7. 217 – Creating Efficiency Maps for 3-Phase Induction Motors

    In this example, the use of JMAG-RT Viewer to create efficiency maps for three-phase induction motors when drive temperatures change.

  8. 203 – No-Load Test Analysis of Power Transformer

    This example focuses on modeling in the analysis of no-load tests in JMAG and obtains the iron loss distribution, current, excitation conductance, and excitation susceptance that …

  9. 221 – Confirmation of the Influence in the Reduction of High-Frequency Resistance of a Magnetically Plated Wire Choke Coil

    In this example, high frequency resistance values are obtained from choke coil copper loss analysis results using JMAG’s layer coating mesh function, and the effectiveness of redu…

  10. 202 – Core Stray Loss Analysis of Power Transformer

    This document introduces runs analysis by modeling the short-circuit test that is conducted when evaluating stray loss and obtains stray loss distribution in the core close to the…

  11. 232 – Reactor Joule Loss Analysis

    In this example, investigating Joule loss with respect to the positions of air gaps in a reactor is presented.

  12. 227 – Circuit Control Simulation for Three-Phase Induction Motor

    In this example, we conduct a circuit simulation to control current and speed by incorporating the JMAG-RT model of an induction motor into the control/circuit simulator.

  13. 206 – Temperature Analysis of an Oil-Immersed Transformer Using a Coupled Magnetic Field and Thermal Fluid Analysis

    This document introduces, examples and steps will be shown to obtain heat distribution in a magnetic field analysis for a forced circulation type oil-immersed transformer, map the…

  14. 199 – Efficiency Analysis of Wireless Power Transfer via Electromagnetic Induction Method using Resonance Circuits

    This example presents, an electromagnetic induction-type wireless power supply system using an excitation circuit positioned with a parallel resonance condenser on the receiving e…

  15. 198 – Bus Bar Thermal Stress Analysis

    Here, temperature distributions for bus bars are obtained when the power supply frequency is changed.

  16. 190 – Arrangement Optimization of Wireless Power Transfer System

    This document introduces the procedure in obtaining the optimum solution for geometries of transmission coils (angle that defines position) for simple magnetic resonance wireless …

Search Filter

  • All Categories