DP
Transient Magnetic (2D/Axisymmetric)
- Sort condition
- Newest first
- Oldest first
- Large number of views
-
[JAC210] Torque Decoupling of In-out Magnet Coupling
This document, presents an analysis for finding holding torque and an analysis for transient response during torque decoupling.
-
[JAC265] Creating Synchronous Reluctance Motor Efficiency Maps
In this example, the efficiency map of a synchronous reluctance motor is created with loss ratios at each operating point also evaluated.
-
[JAC276] Six-Phase IPM Motor Harmonic Iron Loss Analysis
In this example, confirming the effects of carrier harmonics on the iron loss of a six-phase IPM motor are explained here.
-
[JAC103] Efficiency Analysis of a Permanent Magnet Synchronous Motor
In this example, how to obtain the efficiency with a sinusoidal wave voltage drive at a rotation speed of 1,800 r/min and voltage amplitude of 40 V.
-
[JAC211] IPM Motor Wire Joule Loss Analysis
In this example, evaluation of coil joule loss that includes eddy currents during motor rotation is introduced here.
-
[JAC275] IPM Motor Iron Loss Analysis Accounting for the Effect of Residual Strain
In this document, an analysis of an IPM motor accounting for the residual strain that occurs as a result of punching processes, and evaluates the effect on torque, magnetic flux d…
-
[JAC231] Vector Control Simulation of a Synchronous Reluctance Motor
In this example, circuit simulation is carried out simulating the control of current and speed by loading a JMAG-RT model for a SynRM into a control/circuit simulator. In addition…
-
[JAC230] 6-Phase SPM Motor Inverter Fault Simulation
In this example, a JMAG-RT model of a 6-phase SPM is loaded into a control/circuit simulator, and circuit simulation for an inverter failure is carried out.
-
[JAC274] SPM Motor Thermal Demagnetization Analysis Using Bonded NdFeB Magnets
In this example, an SPM motor thermal demagnetization analysis is performed using bonded NdFeB magnets. Both the influence on torque waveforms when changing rotor magnet temperatu…
-
[JAC257] IPM Motor Topology Optimization
In this example, rotor core maximum stress and radial direction maximum displacement in the radial direction are set to certain values or less, and rotor geometry is designed that…
-
[JAC225] Induced Voltage Analysis on Memory Motors Using Variable Magnets
In this example, the change in motor characteristics are checked as the memory motor variable magnet magnetization is changed using the three-phase coil current. One example of mo…
-
[JAC259] Automatically Searching for Current Phase that Obtains Maximum Torque and Evaluating Torque Characteristics
In this example, the current phase that maximizes the torque is searched for each of three rotor geometries. The motor average currents and torque ripples are evaluated using the …
-
[JAC252] Geometry Optimization of a Solenoid Valve
In this example, an example where the geometry of a solenoid valve is optimized using a multi-objective optimization algorithm is presented.
-
[JAC261] SPM Motor Magnet Coercive Force Optimization For Obtaining Sinusoidal Magnetization
In this example, a magnet is segmented into blocks and coercive force is defined. The coercive force of each block is calculated so that the induced voltage waveform approaches a …
-
[JAC200] Iron Loss Analysis of IPM Motor using Hysteresis Model
In this example, a hysteresis model accounting for minor loops of the direct current bias magnetism and the lamination analysis function accounting for eddy current distribution i…
-
[JAC244] Magnetic Field Strength Analysis at a Sensor Position
In this example, with the analysis target being a motor and the detection sensor being a TMR sensor, an example where a detection signal waveform is obtained that is based on magn…
